Last Activity:03-05-2014 3:28 PM
Likes Given: 5
3 Likes on 3 Posts
Posted in thread: 240v Receptacle On Element Box? on 03-05-2014 at 09:01 PM
Kal has a good point. I use the brewhardware element enclosures as I have tri-clamp fittings.
The stick out pretty far, and the stiff cord sticks out every further. I may replace at some
point with a ...
Posted in thread: Stir plate : To much spin? on 02-27-2014 at 08:43 PM
I'm not sure if a crazy vortex would hurt your yeast. I do know you do not need a vortex of any
kind to make a good yeast starter. All you need the stir plate to do is keep the yeast moving
and in sus...
Posted in thread: Contactor Wiring on 02-25-2014 at 05:18 PM
And I have a related (contactor wiring) question, I bought the Auber SYS-2352 PID and SSR.
Auber recommends wiring the contactor before the SSR but in PJ's schematics and Kal's drawings,
Posted in thread: Hoppo's E-Brewery Build on 02-17-2014 at 03:07 PM
Wow that drop ceiling really brightened up the place! Very nice job on the build.
Posted in thread: HomeBrewTalk 2014 Big Giveaway on 02-14-2014 at 03:27 PM
I'm all in!! :ban:
Posted in thread: New conical set up, what do you think? on 02-13-2014 at 08:14 PM
Is the condensation line in the last picture the 10g mark? What kind of cooling range do you
have from ambient? What kind of conicals did you get? If you are going to add a custom internal
Posted in thread: Hunter's Basement E-Brewery Build on 02-13-2014 at 02:38 PM
Thank you Hunter. I am glad I came across your build. I nearly bought the Greenlee at a much
higher price tag for just 1 hole. I would have listed it on eBay once done but this tool is
cheaper than wh...
Posted in thread: Keggle Element Placement on 02-12-2014 at 09:35 PM
I used Bobby M's solder on tri-clover element enclosure and I put it on as low as I could. Than
being said the weld-less dip tube I have/had I couldn't get any lower than the solder on
Posted in thread: Soldering Stainless steel on 02-11-2014 at 05:54 PM
I used a small propane torch.
Posted in thread: Soldering Stainless steel on 02-11-2014 at 01:57 PM
I use an angle grinder with a fine grit polishing pad. 10 seconds and it's shinny as new.