Last Activity:05-29-2009 4:02 PM
Posted in thread: Looking to expand, buying new equipment. on 04-29-2008 at 05:27 PM
While all of these recommendations are good, the one with the most impact and probably the
cheapest would be making the jump to AG. You have a pot that you could do full boils in, you
just need to get...
Posted in thread: Drip trays on my new keezer on 04-23-2008 at 06:29 PM
I can't recall what catalog I saw it in now, but they had a very interesting solution I plan to
use myself. Basically it was wire (copper it looked like) that was twisted in a cool fashion to
Posted in thread: Recommend a good kit?? on 04-22-2008 at 08:50 PM
I assume you are referring to an equipment kit rather than a recipe kit. That being said, I
believe just about any kit is going to have the basics. I noticed some kits now have a cheap
one use thermom...
Posted in thread: Carboys on Ebay... Is this possible??!!??!! on 04-11-2008 at 02:36 PM
I've had several (2 or 3 anyway) Wii auctions pulled for "erroneous" shipping charges over the
last 18 month. What's erroneous you ask...20 bucks according to ebay.
Posted in thread: Quick Disconnects: Plastic? Brass? SS? on 04-08-2008 at 04:39 PM
Go for the yellow brass, wear gloves when disconnecting from something hotOne of my club
members suggested putting silicone "sleeves" on the females to insulate. I thought this was a
fantastic idea to...
Posted in thread: Tax Return/Economic Stimulus funds..... on 04-07-2008 at 09:34 PM
is what consumer reports recommends!I have something similar an it will hold 6 kegs with room
Posted in thread: Is a street light going to mess with my hops flowering? on 04-02-2008 at 05:36 PM
I've done a good amount of indoor gardening over the years and I highly doubt this is going to
be much of an issue. The light has dissipated so greatly by the time it reaches the ground its
Posted in thread: Removing left over copper on 04-02-2008 at 04:50 PM
If you have access to the inside from one end, just roll up a piece of sand paper and go to
Posted in thread: Fear the Banjo on 03-31-2008 at 04:12 PM
The more I think about it, the more I gotta believe that a 30 PSI reg is going to allow more
propane through than a 20 PSI regulator. The pressure in the propane tank itself is around 100
psi. You nee...
Posted in thread: Fear the Banjo on 03-28-2008 at 06:57 PM
I can't find jack about getting the right mix, so I'll do my best to explain. Since the number
is higher, you assume more gas would be passing through, however, this is misleading, as its