VIEW MY

dmcman73

Gift Premium Subscription To dmcman73

Join Date:

04-28-2013

Last Activity:

08-04-2015 7:24 PM

Likes Given: 9

71 Likes on 60 Posts 

LATEST ACTIVITY

  • Posted in thread: What are these? on 08-04-2015 at 03:24 PM
    Just be careful when removing and installing the posts. If you feel it bind up a bit, stop.
    Stainless likes to gall up when you try to force thread and it will seize.

  • Posted in thread: Hanna pH meter on 08-04-2015 at 12:35 PM
    I just recently purchased a Hanna pH meter (HI98127) off Amazon a few months back. I never got
    a chance to use it but I opened it up and added storage solution to it for the sensor.Yesterday
    I decided...

  • Posted in thread: Keggle- issue after cutting the top off on 08-03-2015 at 08:18 PM
    I cut the bottom of my keg with a grinding wheel and didn't have any of that on the inside of
    my keg so I am leaning towards Plasma Cutting since that generates an enormous amount of heat,
    the stainle...

  • Posted in thread: Distance between false bottom and heating element on 08-03-2015 at 08:13 PM
    My suggestion would be to drill two holes in each leg (close to the opposite ends of the legs)
    and use a Stainless Hex bolt with two stainless nuts to hold it firm (the head of the Hexbolt
    would be th...

  • Posted in thread: Show me your ventilation on 08-03-2015 at 12:46 PM
    2937312937322937332937341. Nice build!2. I couldn't help but think that this whole setup
    belongs on the back of the DeLorean in back to the future!

  • Posted in thread: Distance between false bottom and heating element on 08-03-2015 at 12:43 PM
    The use of a false bottom, properly installed, means the element is kept apart from the grain.
    It cannot scorch what it cannot touch.Isn't this what the whole thread is about? The heating
    element was ...

  • Posted in thread: Kegerator not cooling down on 08-03-2015 at 12:06 PM
    Here's the page I was referring too, I circled in red what I think looks like a service panel
    under the unit.

  • Posted in thread: Kegerator not cooling down on 08-03-2015 at 12:02 PM
    I just looked at the owners manual for that unit online. There is a section where it shows how
    to reverse the door swing and when it shows how to remove the lower bracket, I see what looks
    like a serv...

  • Posted in thread: Kegerator not cooling down on 08-01-2015 at 06:48 PM
    Depending on where the leak is and how big, it could be brazed and repaired. They have freon
    with UV dye in it. Charge it and wait, then use a UV Light to find the leak. If it glows
    purple, you'll see...

  • Posted in thread: Best Stainless Conical??? on 08-01-2015 at 01:34 AM
    I own a 7 gallon and 14 gallon one from ss Brewtech and they are great. The valves are less to
    be desired but the build quality for the fermenter is excellent and the optional temp
    controller works aw...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS