VIEW MY

dmako

Gift Premium Subscription To dmako

Join Date:

02-10-2008

Last Activity:

02-11-2012 10:27 AM

LATEST ACTIVITY

  • Posted in thread: Outdoor Brewing to Indoor Fermenting on 05-05-2010 at 11:34 PM
    I brewed outside last week for the first time on a propane burner, its the way to go!But I was
    wondering could one 'skunk' the beer if boiling in sun light? I kept in the shade.

  • Posted in thread: Keg pressure question on 01-30-2010 at 03:54 PM
    Beginner kegger, I have my beer in a corny for 5 days at 10PSI @ 35-40 degrees in my cellar
    hatchway. On day 5 I sampled a beer, nice had a good foamy head. Then I put the pressure down
    to 5PSI figuri...

  • Posted in thread: New to corny kegs questions II on 01-25-2010 at 10:22 PM
    Okay I have my first corny kegged and under pressure (10PSI). Now when I brew up another batch
    can I after several week unhook my carbonated keg and hook up to my new 2nd keg?So I make a T
    connection ...

  • Posted in thread: My first attempt at kegging, comments? on 01-24-2010 at 06:06 PM
    Follow upIt seems that was the gas in pop-it gasket. I guess a true dry test should be done
    with the CO2 left attached as the leak only occurred when the quick connect was attached.

  • Posted in thread: My first attempt at kegging, comments? on 01-23-2010 at 11:24 PM
    You should look into that. Connections should not be so susceptible to leaks. Where is it
    leaking? Quick-disconnects? Flare nuts? One common mistake people make is using teflon tape or
    such on flare c...

  • Posted in thread: My first attempt at kegging, comments? on 01-23-2010 at 11:02 PM
    It could be the position of the connectors or it could be old orings not sealing well in the
    connectors. I would go with matt's post and make sure the connector is positioned right. Plan
    on replacing ...

  • Posted in thread: My first attempt at kegging, comments? on 01-23-2010 at 10:54 PM
    Leave it connected and just take some soapy water and pour/spray it over anything that can leak
    and look for bubbles. Once finished grab a hose and rinse the heck out of it. If it is leaking,
    then it ...

  • Posted in thread: My first attempt at kegging, comments? on 01-23-2010 at 10:39 PM
    I just filled my first corny keg a few hours ago and plan on doing the following unless my plan
    is faulty.I set the CO2 pressure at 10 psi since I have the corny in my hatch way which is
    around 35 - 4...

  • Posted in thread: CO2 Cylinders In Seattle Area on 01-18-2010 at 09:43 PM
    You may want to check a fill place. Someone gave me a tank and the only way to get it filled
    around here (CT) is to swap it for a filled one. So fif I had bought one it would be swapped
    for an used on...

  • Posted in thread: Does CO2 go bad? on 01-13-2010 at 11:14 PM
    If that is the most current date on the tank then you are going to need to get the tank
    re-tested before it gets filled again. Who ever you were planning on taking it to should know
    of a place to get ...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS

PHOTO OF THE DAY