Last Activity:02-28-2015 4:56 PM
Posted in thread: are tri-ply pots preferred for induction burners? on 02-21-2015 at 02:10 AM
Check out Jarhill pots on EBay. They are 410 stainless and inexpensive. I have them (I don't
use induction heating) and a magnet sticks just fine. They are thin and don't have a a tri-clad
Posted in thread: Spike Brewing 20 Gallon Sight Glass Kettle Giveaway! on 02-11-2015 at 03:33 PM
Posted in thread: BrewHardware.com RIMS hardware Kit and more Giveaway! on 01-06-2015 at 06:19 PM
Posted in thread: PJ diagram modification on 12-31-2014 at 04:18 PM
Option 1- Put a probe in both, just switch the wire between the two. Easy enough to do with
most of the temp probes out there as they come with a quick connect at the probe.Thanks for the
input. This ...
Posted in thread: PJ diagram modification on 12-27-2014 at 05:33 PM
Great. Thanks for the feedback.Can I use the same switch (Auber SW2) and just stack another
pair of NO/NC blocks on the switch? These.
Posted in thread: PJ diagram modification on 12-24-2014 at 06:17 PM
I'm building a control panel based on one of PJ's diagrams, but I want to add one of the new
Auber DSPR1 for boiling control. I've modified this diagram and wanted to get some feedback to
see if I've ...
Posted in thread: BrewsbySmith DIY Kit plus STC 1000 Temp ControllerGiveaway! on 11-27-2014 at 09:27 PM
Posted in thread: The SsBrewingTechnologies "Happy HolidaySs" Giveaway! on 11-17-2014 at 07:52 PM
Posted in thread: ElectricBrewingSupply 30A BCS Control Panel Giveaway! on 10-15-2014 at 11:48 PM
Posted in thread: FastFerment conical fermenter?????? on 10-13-2014 at 09:54 PM
Now we just need a 9mm temp probe. I've been scouring eBay with no luck. Any ideas?If the OD of
you probe is less than 9mm you could just use some heatsink thermo paste to make good thermal