Last Activity:11-29-2015 9:51 PM
Likes Given: 7
58 Likes on 40 Posts
Posted in thread: Ss Brewtech’s Biggest Baddest Holiday Giveaway Ever! on 11-25-2015 at 12:17 AM
A moose once bit my sister...
Posted in thread: IRIMS is here! on 08-10-2015 at 01:05 PM
I haven't had time to follow up on this. I think the 120v version I put together shows promise
for 5 gallon batches with some insulation.It maintained temps with no insulation and the lid
off the tun ...
Posted in thread: Coldbreak Brewing Herms Giveaway! on 07-16-2015 at 01:43 AM
In like Flynn
Posted in thread: IRIMS is here! on 07-13-2015 at 07:31 PM
Any updates?I haven't had a chance to work on it any more (life keeps interrupting me).I hope
to be able to insulate the foo out of it and test again in a few days.
Posted in thread: IRIMS is here! on 07-04-2015 at 02:46 PM
I just completed a wet test. The setup was:8 gallons of water circulating through my boil
kettle (whirlpool). My March 815 pump was set to half throttle and I use 1/2" silicone lines.
The IRIMS device...
Posted in thread: IRIMS is here! on 07-03-2015 at 01:27 PM
I just did a wiring test with 7 of the 300 watt heaters on a 12" extension tube. I capped one
end and filled it with water, left the other end open of course.So far so good. It heated the
tube full of...
Posted in thread: IRIMS is here! on 07-01-2015 at 04:15 PM
Well, this thread has kinda died...Anyway, I'm expecting the rest of my band heaters and the
stainless pipe to be delivered today, so I should be able to experiment with it soon. Also, it
looks like a...
Posted in thread: IRIMS is here! on 06-29-2015 at 06:05 PM
I'll definitely report back. I'm going to test it with the minimal amount of parts necessary to
see if the temperature rise rate is sufficient for my needs.If I determine that it can manage
it, my nex...
Posted in thread: IRIMS is here! on 06-29-2015 at 05:06 PM
Trimix, I'm going to try this out. Did you coat the flat wires between the element and the
ceramic block and then slide the fiberglass insulation back on?Any other tips/tricks you
learned while assemb...
Posted in thread: IRIMS is here! on 06-26-2015 at 06:40 PM
Trimix, will those band heaters tolerate being dry fired when installed? Just wondering if the
tube could be pre-heated a bit in order to keep it from cooling the mash initially.Thanks for a