Last Activity:06-04-2014 12:13 PM
Posted in thread: Can draft lines be split to multiple faucets? on 05-16-2012 at 08:33 PM
Another option may be to use less resistant lines (1/4 ID) for the basement bar and more
resistant lines (3/16) for the kitchen, but that's just a guess. Good luck!I think that if the
basement is bel...
Posted in thread: eBrewSupply - Electric Brewing Hardware Opening Soon on 05-03-2012 at 06:27 PM
Coupon please!!! Best of luck.
Posted in thread: Mazzei Venturi Aeration System on 04-16-2012 at 05:42 PM
What about this?
Posted in thread: Mazzei Venturi Aeration System on 04-16-2012 at 04:30 PM
Nicely done, I was thinking about doing the same except adding a nipple to add pure O2 for high
Posted in thread: Anyone using a 6" vortex inline with a 4" reducer? on 04-13-2012 at 08:29 PM
I have but then I gotta buy crimping tool and cutter which looked like $75 bucks!
:drunk:Self-tapping screws, tin snips and some aluminum tape should be all you need. I've only
worked with it replacin...
Posted in thread: Anyone using a 6" vortex inline with a 4" reducer? on 04-13-2012 at 08:24 PM
Stick with 6 if you can. 4" will halve your flow rate. Have you looked into metal ducting?
Posted in thread: Poplar or Oak for a Mash Paddle? on 04-13-2012 at 01:49 AM
I'd go with cherry or poplar. Oak is very porous compared to those two.
Posted in thread: Kegerator Tip?? on 04-11-2012 at 01:46 AM
Measure the hole and go to Ace Hardware. They sell grommets
Posted in thread: air in the tap line on 03-19-2012 at 05:32 PM
Ok so I am brand new to kegging and I am on my second keg (the first one turned out great!) and
no matter what I do I am getting way to much carbonation and I think part of the problem is the
Posted in thread: Bottle filling rate and oxidation on 02-09-2012 at 04:35 PM
I don't know if it makes a difference but, I start slow until the spray tip is submerged and
then push down fully.