Last Activity:10-09-2013 10:23 AM
Posted in thread: How many taps do you have or on 06-25-2013 at 12:14 AM
10 on my Kegerator .. at 22 cu foot converted chest freezer. Pic on the forum page at
Brewcommune dot comDan
Posted in thread: Stainless Accessories on 03-12-2013 at 03:22 PM
I finally ordered and received my new 50 mesh sleeve from Zach and have brewed with it and it
works like a charm. Dan
Posted in thread: Stainless Accessories on 12-10-2012 at 04:33 PM
IMHO boiling for 90 minutes may do more for reducing DMS than keeping the lid off for cooling.
I've seen a bunch of Jamil recipes that call for 90 minute boils specifically for reducing
Posted in thread: Stainless Accessories on 11-28-2012 at 08:27 PM
EDIT 2: MICRON!!!!!!! 300, 400, and 500 MICRON is what I was referring to. Which seems to
correlate to #30, #40, and #50 mesh.I'm not the expert but I do think that you're backwards as
quoted above .....
Posted in thread: Stainless Accessories on 11-28-2012 at 06:45 PM
I think you have an extra 0 (zero) on those mesh sizes but you do have the filtration effect
correct. I'm not positive but I believe that the "mesh size" refers to a "per inch" measurement
so you can ...
Posted in thread: Stainless Accessories on 11-27-2012 at 01:04 AM
What mesh was this?Looks like he got the 40 mesh based on his previous post ... had wanted the
50.Based on what I've seen here I think I want a sleeve of 50 mesh.Tell me Markd27 ... which
temp gauge i...
Posted in thread: Stainless Accessories on 10-26-2012 at 03:48 PM
Well a 50 mesh was used this weekend with great straining results but the boil is more mild
than preferred. I think the 40 mesh might be the best route.Any progress on the 40 mesh
Posted in thread: Stainless Accessories on 10-21-2012 at 04:37 AM
Will let you know after tomorrow's test.DanThe new coils made a big improvement in
heating/cooling efficiency ... probably in large part due to the increased flow rate stepping
up to 0.500" from .300...
Posted in thread: Stainless Accessories on 10-16-2012 at 09:32 PM
Well, I did have to do some bending ... you had the angles right but the geometry coming from
across the coils versus from the same side was different. I had just enough material to make it
work. I on...
Posted in thread: Stainless Accessories on 10-16-2012 at 05:49 PM
Zach:Looking forward to seeing the 40 mesh results ... then I'll decide. The 50 looks good
though. I'll keep my 30 mesh for whole leaf hops and then use whatever the other is for
pellets. BTW, I'll be...