Last Activity:10-24-2016 3:18 AM
Likes Given: 4
7 Likes on 5 Posts
Posted in thread: Need Schooling on HERMS Fly Sparging on 10-10-2016 at 04:39 PM
Thought I would report back on this thread. My last brew day was much more predictable. I took
advice offered and removed the elbow and short hose on my MLT and replaced with ~4' tubing
which wrapped ...
Posted in thread: Need Schooling on HERMS Fly Sparging on 10-06-2016 at 12:26 PM
Thanks for the feedback everyone. I do crush my own grain and my mill is set to a .033" gap. I
do not anticipate the mill adding to the variability. I think I will remove that elbow and put
a longer h...
Posted in thread: Need Schooling on HERMS Fly Sparging on 10-04-2016 at 04:13 AM
I would like some feedback on my fly sparging technique, my resulting efficiency has varied
from 66% to 90% over 5 batches. I have been a batch sparger for 5 years but I retired my cooler
MLT this yea...
Posted in thread: Designing a new brewery and need a cad file on 11-08-2015 at 06:56 PM
Yavid you are awesome. This post deserves a bump for anyone looking for CAD models for
equipment design. The links still work.
Posted in thread: Advice for Manual Propane Single Tier Brew Set-up on 10-27-2015 at 02:42 AM
So some of my improvised first generation brewing equipment has finally kicked the bucket after
5 years. Bad news - really annoying surprise on brew day finding your copper cooling coil has
Posted in thread: Danby DAR125SLDD Kegerator Build on 01-11-2014 at 05:23 PM
I used super glue to attach my gas manifold to the side. Works just fine, no risk of hitting
Posted in thread: Danby DAR125SLDD Kegerator Build on 01-02-2014 at 12:40 PM
Welcome mtnagel, enjoy the kegerator! Let us know how trimming the shelf supports go.
Posted in thread: Danby DAR125SLDD Kegerator Build on 01-15-2013 at 01:15 PM
how much wiggle room do you have with one ball lock and one pin lock? I am thinking about
putting in a ball lock and a sixth commercial keg. the ball lock is 8.5" diameter and from what
I gather onlin...