Last Activity:01-17-2017 6:42 AM
19 Likes on 10 Posts
Posted in thread: What Would Happen If... on 10-16-2015 at 03:33 PM
I have not used that specific "juice", but have fermented others similarly. You tend to lose
the flavor of the juice for the most part after it ferments. Also, depending on the additives
it may not fe...
Posted in thread: Need to increase AG capacity and need sugggestions on 10-16-2015 at 03:08 PM
What pre-boil volume are you attempting to boil? I am questioning why you cannot use your
current 15g pot. Even if you were boiling off 2 gallons per hour, that still leaves you 3
gallons of initial h...
Posted in thread: Signs of fermentation on 10-16-2015 at 02:57 PM
It would seem that you have 2 indications of fermentation. Smell and warmth. Have you tried to
push the lid down tighter? Assuming it is a snap on lid and not threaded. RDWHAHB! :tank:
Posted in thread: Tower extension, anyone use one? on 10-01-2015 at 12:28 PM
They started out as new old stock from a part store that went out of business. They are early
Edsel/Hudson/Ford/... connecting rods. They were coupled to "turnbuckles" that are used to
stretch fences ...
Posted in thread: Tower extension, anyone use one? on 09-28-2015 at 02:41 PM
I put extensions on my old kegorator. They worked great for adding 4 more taps. Installing them
can be somewhat cumbersome since you are cramming more lines and faucets into a small area.
Posted in thread: Cooling with ice on 09-25-2015 at 02:05 PM
I assume you are boiling your wort and then topping off with water? If so, put the top off
water in the refrigerator or freezer before brewing so that when you add it in, it will drop
your temps witho...
Posted in thread: FastFerment conical on 09-24-2015 at 07:38 PM
I ended up buying a SS coil and bulkhead qc fittings for an internal chiller. Basically a wort
chiller with ice water / glycol. I will wrap the outside in heat tape of the equiv just like my
Posted in thread: FastFerment conical fermenter?????? on 09-23-2015 at 02:14 PM
DeBrewer....Sweet setup!:DThank you! Well, I will pass on the praise to the Seamstress Who Must
Be Obeyed. She is going to make a cover to go over it out of some black material that will
Posted in thread: BCS Firmware 4.0 Released on 09-23-2015 at 12:05 AM
Manual "mode" is not needed... The main control page gives you all the manual control you like.
You can turn outputs on/off and see inputs right on the page. -BDGotcha. Thank you for the