Last Activity:09-04-2016 9:27 PM
Likes Given: 7
2 Likes on 2 Posts
Posted in thread: Purged keg of oxy, let sit for 2wks. Still force carb? on 10-14-2015 at 02:40 AM
Awesome, thanks everyone! I'll burst carb overnight, then back it off. I just wanted to make
sure I wasn't going to mess anything up with the little bit of CO2 I had in there from purging.
Posted in thread: Purged keg of oxy, let sit for 2wks. Still force carb? on 10-14-2015 at 01:39 AM
I kegged my beer 2 weeks ago, purged oxygen at about 10psi, and let sit until now, when I've
got room in my kegerator.Do I still need to let it sit at 30psi for 24hrs, then back off to
Posted in thread: Help with 1st kegerator purchase on 09-05-2015 at 12:28 AM
If you can get stainless steel everything! Better to pay for it now. It'll cost more to upgrade
Posted in thread: Show me your Keg Label Ideas! on 09-05-2015 at 12:26 AM
I painted the front of my kegerator with chalkboard paint and just write what's on tap. Also
chalk is fun! :tank:
Posted in thread: Gas enters regulator, but won't go out to kegs on 09-03-2015 at 04:37 AM
C'mon now!You can level with us, we won't tell anybody.....................:DHa, seriously! I
don't doubt I was just being dumb the whole time, but I have nothing to prove or disprove that!
If I ever ...
Posted in thread: How should I cover accidentally made holes?! on 08-31-2015 at 01:59 AM
Cut some cheap rigid plastic or thin wood and glue it to the backside of the holes. Then fill
the front with bondo or similar material that is slightly flexible and won't shrink when
drying. Sand flus...
Posted in thread: How should I cover accidentally made holes?! on 08-31-2015 at 01:25 AM
A picture might be helpful, but perhaps you can cover the holes with a hanging drip
tray...Cheers!Thought about that, those are a bit out of budget for right now, and my fridge
isn't flat on the front...
Posted in thread: How should I cover accidentally made holes?! on 08-30-2015 at 10:51 PM
If your chaulk board painting...Unfortunately I already painted it! Lesson learned, I suppose.
Posted in thread: How should I cover accidentally made holes?! on 08-30-2015 at 10:21 PM
When I did a dry fitting of my kegerator insides, everything seemed fine. But I forgot to check
clearance with the beer lines attached to the shanks! :smack:I drilled new holes higher up to
clear my k...
Posted in thread: Changing in and out on a keg? on 08-30-2015 at 04:20 PM
fwiw, if you shut off the gas feed overnight and this beer hasn't been fully carbonated, you
can expect the pressure to drop...Cheers!Oh, this keg has no beer, it's empty. I just wanted to
see if it w...