Last Activity:03-07-2014 12:01 AM
Likes Given: 3
15 Likes on 14 Posts
Posted in thread: Need help! Y8610U pilot kit, Diagram included on 03-06-2014 at 05:37 AM
I would start by checking for voltage across PV & MVPV while you have a call for ignition. If
voltage is present it could be the inlet pressure or possibly the pilot pressure.
Posted in thread: How do you sanitize your plate chiller prior to chilling? on 02-25-2014 at 05:21 AM
I second the 180 degree water for about 10 minutes and call it good. Afterwards agood flushing
with PBW and hot water.
Posted in thread: Single Tier Brew Stands? on 02-06-2014 at 08:50 PM
177528You can get larger flexible connectors. I am using ones that are 13/8" id and they work
Posted in thread: Banjo burner problems on 02-06-2014 at 02:56 PM
Are you getting the pop with the pot off? If not it is starving for oxygen and you need to put
some spacers under the pot to give it more air.
Posted in thread: Banjo burner problems on 02-06-2014 at 05:55 AM
You might want to try turning down the gas pressure a little or verify they are set at 11"WC.
Posted in thread: [Initial Release] RaspberryPints - Digital Taplist Solution on 02-03-2014 at 02:25 AM
Will the Raspberry Pi Model A work for this project?
Posted in thread: Help Needed With Propane Burner Issue *PID Controlled* on 02-01-2014 at 09:25 PM
I Have the same set up and when mine was doing that it was a low pressure issue.
Posted in thread: Brew System I've been building on 01-25-2014 at 12:12 AM
Posted in thread: Need help! Y8610U pilot kit, Diagram included on 01-22-2014 at 04:03 AM
What's the date code on it? You may be able to get a local Johstone or Grainger to replace them
Posted in thread: Need help! Y8610U pilot kit, Diagram included on 01-21-2014 at 06:43 AM
Check out the diagram on page 12 and it should clear up your problem. universal ignitors are
awesome by the way. I got samples when they first came out and love them.