Last Activity:12-27-2013 11:46 AM
1 Likes on 1 Posts
Posted in thread: Tap-Rite 5740 regulator rebuild on 04-16-2013 at 11:57 AM
Posted in thread: Tap-Rite 5740 regulator rebuild on 04-15-2013 at 06:18 PM
I have a dual gauge dual regulator that I want to rebuild. I have the bell off but how do you
remove the pin assembly.
Posted in thread: # Moding a KRS-2100 to put the CO2 tank on the outside. on 06-05-2012 at 07:11 PM
Cool wait long enough and your questions get answered.Dan
Posted in thread: Another Fermentation Chamber Build on 04-26-2012 at 06:04 PM
I gutted a small dorm fridge but built the compressor into this and it works fine.
Posted in thread: DIY Mash Tun with Manifold on 04-26-2012 at 05:29 PM
With the angel of the drain hole in my cooler the lowest point of the ball valve is about the
same level as the bottom of the cooler. If I attach a hose barb with a hose I should be able to
Posted in thread: DIY Mash Tun with Manifold on 04-26-2012 at 05:18 PM
is the zinc washer on the outside of the MT? i.e., does not come in contact with mashThe drain
for this cooler is on the back side. I put the round 1/2 rubber washer over the nipple, then
the zinc was...
Posted in thread: DIY Mash Tun with Manifold on 04-26-2012 at 05:10 PM
The first thing I did was measure the bottom area of the cooler so I could design my manifold.
Next I cut all the pieces and laid them out on the floor. I test fitted it all together
removed the dra...
Posted in thread: DIY Mash Tun with Manifold on 04-26-2012 at 04:20 PM
So after building my fermentation chamber I decided to make me a Mash Tun so I can go all
grain.The parts:I got this cooler from Walmart for $29 Ball valve from HD $7.32 copper 1/2
Tee's .99c each ...
Posted in thread: Keg Spear CO2 valve on 03-29-2012 at 01:26 PM
Thanks for the info.Dan
Posted in thread: Help finding Keg Part on 03-29-2012 at 10:55 AM
I need the CO2 valve for a RS-D spear. Does anyone know where I can get one.Brewman