Last Activity:02-19-2014 12:19 PM
1 Likes on 1 Posts
Posted in thread: The Green Keezer on 09-21-2013 at 11:53 PM
My 1/6 barrel of Sam Adams Octoberfest came in today! few weeks ago I called several
distributors in my area I learned that my favorite domestic Miller Lite only comes in full
sankey 1/2 barrels or ...
Posted in thread: The Green Keezer on 08-27-2013 at 04:15 AM
With some help of good friends (who like free beer) we finally polished off that half barrel of
Lite a few weeks ago with pouring out the first half pint of each evening. Tonight I went back
to work o...
Posted in thread: The Green Keezer on 06-07-2013 at 11:55 PM
After doing a little investigating, the pump I have is a submersible/inline, just had to remove
the mesh cover to expose the intake threads. That of course required another special order from
Posted in thread: The Green Keezer on 05-11-2013 at 12:52 AM
To those who say my design was too complicated - well you're right! I didn't take into
consideration the heat output on a 2000GPH pond pump. After 16 hours in the keezer, the keezer
temp had risen to ...
Posted in thread: The Green Keezer on 05-07-2013 at 11:15 PM
I'm on the home stretch!!Yesterday the part from Grainger arrived and I hooked up the pond pump
to the cooling lines only to discover I had 2 kinks in the copper coil inside the keezer from
Posted in thread: 8.8 cubic foot (9) Frigidaire keezer build on 05-07-2013 at 01:41 AM
Sub'd - looks great so far.
Posted in thread: The Green Keezer on 05-06-2013 at 08:11 PM
Water would probably work, but I like my beer as close to 32 degrees as I can get it! The
antifreeze ensures I won't have frozen cooling lines.
Posted in thread: The Green Keezer on 05-06-2013 at 01:46 AM
I probably would have built a chest keezer on wheels that I could just roll in and out of the
house (I see the sliding door) when you needed it. It just seems like there is a lot that can
go wrong the...
Posted in thread: The Green Keezer on 04-27-2013 at 04:03 AM
I had the day off work so got quite a bit done this afternoon. Only 3 trips to Home Depot in
total!! First up was to drill a hole through the bar top to meet the PVC. I cut the PVC off
flush with the...
Posted in thread: The Green Keezer on 04-22-2013 at 06:26 AM
After doing some more research tonight, I've decided to swap out the 3/8" vinyl cooling line
for 3/8" copper tubing. Now the question is, do I wrap the two beer lines along both the
outbound and retur...