Last Activity:12-17-2013 6:18 PM
Likes Given: 1
32 Likes on 27 Posts
Posted in thread: My Single Tier Strut Brewstand on 12-03-2013 at 01:34 PM
Nice job boss. I am looking to do pretty much exactly what you did with the gas. At the risk of
asking a dumb question here, for each side of the Y (manifold I suppose some fancy pants would
Posted in thread: My Single Tier Strut Brewstand on 12-02-2013 at 08:36 PM
These are what I used to secure them to my stand:
flipped them so that the angle went over and around the ...
Posted in thread: Rebel Brewer Giveaway! on 11-21-2013 at 10:28 PM
Count me in!
Posted in thread: DIY Oxygenator for Sankey Transfer on 11-20-2013 at 10:05 PM
I might be able to take the one from Morebeer and adapt it to work for me. below is a reversion
of what I am looking to do which is make a device that I can insert into my fermentor (keg) and
fill it ...
Posted in thread: DIY Oxygenator for Sankey Transfer on 11-20-2013 at 06:04 PM
So I ferment in 1/4BBL Sankeys. I love them and currently to oxygenate my wort I transfer cap
then shake the keg (as much as I can) to get some air into it.I was at the big box hardware
store the othe...
Posted in thread: Gunk at the top of carboy on 11-19-2013 at 12:40 PM
This is one of the reasons I moved to a Stainless Fermentor. I think I have thrown out multiple
batches of good beer that just looked wrong to me (I am sure it was good)... Now I can't see
it, use Co2...
Posted in thread: How do my burners look? on 11-19-2013 at 12:13 AM
Two BG-12's, they seem to be a little orange but on a test run left only very little soot and I
am thinking that was from messing around with the air flow. They did take tap water from about
Posted in thread: Moisture in hoses after brewing.... on 11-17-2013 at 04:11 PM
Some great suggestions, I am set up to recirc through all my vessels but only one at a time.
Posted in thread: Moisture in hoses after brewing.... on 11-17-2013 at 03:44 PM
My pump is bolted in place, I don't mind disconnecting the hoses etc to let them dry but at the
same time I don't want a spider or anything of the sorts crawling up into my pump housing
making a home....
Posted in thread: Moisture in hoses after brewing.... on 11-17-2013 at 02:51 PM
So I have just built a single tier brew stand and did a dry "wet" run last night. Everything
went well just one leak that was easily resolved. Anyhow this morning I go back to my garage to
work on her...