Last Activity:08-03-2015 12:14 AM
Likes Given: 1
2 Likes on 2 Posts
Posted in thread: Stainless tube fittings on 08-03-2015 at 12:14 AM
Just a bump for the new week and to say, MAKE ME AN OFFERSeriously, these are just sitting
here. Make an offer. I dare you.
Posted in thread: Stainless tube fittings on 07-24-2015 at 02:53 PM
I came across some extra tube fittings from when I was building my RIMS, no need for them
anymore. Prefer PayPal gift for payment, but will do USPS MO. 1. Brennan 316 stainless 1/2"
tube x 1/2" female...
Posted in thread: FS: 250ml Flasks on 06-02-2014 at 09:36 PM
I have a lot of 5 250 ml Flasks1 is polycarbonate and says corning, includes an orange screw
cap4 just say pyrex and are glass, only 3 caps for those however.I used these for storing yeast
when I made...
Posted in thread: FS: 2 Pinlock Cornies on 05-20-2013 at 07:27 PM
I was cleaning these two kegs and filled them with oxyclean to soak, then forgot about them.
They froze and the lid pushed into the openings lightly bending either the lid or opening. The
lid is just ...
Posted in thread: Jockey Box - Two Tapper on 05-09-2013 at 01:21 PM
******* SOLD *******I built this for my sisters wedding. Basically the caterer wanted $400 to
rent us a box for a night, so I built this one for right at $300.00. It was used at the
wedding, then rins...
Posted in thread: Lot of Tri-Clamp Fittings on 05-07-2013 at 11:16 PM
SOLDCleaning out the last of my non-essential brewing equipment, found a lot of left over
Tri-Clamp fittings. I'd like to sell as one complete lot, $75.00 shipped. All are stainless,
304 to be exact. ...
Posted in thread: Blichmann Beer Gun + Accessory Kit on 02-11-2013 at 12:33 AM
SOLDI have a beer gun that I have used once, just never liked bottling period. Tubing is all
brand new. Includes the beer gun, cleaning brush, manual, tubing and a gas/liquid pinlock
fitting (they're ...
Posted in thread: RIMS Heat Exchanger Tube on 06-14-2012 at 03:49 AM
paypal sent, your pm box is full though.Curious, your quote "The heating element I use is a
short, high density Camco element"In your original RIMS tube you went the typical route of
ultra low density...
Posted in thread: RIMS Heat Exchanger Tube on 06-14-2012 at 03:46 AM
Two tubes sold. One SPF. Thanks everyone!!
Posted in thread: RIMS Heat Exchanger Tube on 06-13-2012 at 10:32 PM
I'm in need of a RIMS tube, I'm not a flow guy but does having the input to the tub midpoint
cause and stagnation of the flow in the left side near the element? how do you mount your