dandw12786

LATEST ACTIVITY

• Posted in thread: My first brew. Brewer's Best India Pale Ale on 03-22-2013 at 06:10 PM
  Get one of these: have to be from Midwest, any brewing store will sell them. Get a turkey
  baster at the grocery store and you're all set!

• Posted in thread: My first brew. Brewer's Best India Pale Ale on 03-22-2013 at 06:10 PM
  Get one of these: have to be from Midwest, any brewing store will sell them. Get a turkey
  baster at the grocery store and you're all set!

• Posted in thread: Sock for grain bag? on 03-21-2013 at 11:12 PM
  Well, I acknowledge that the advice from all of you was "no". Looked around the house, and this
  was my best option, so I went with it. We'll see what happens! If it tastes like crap, I'll let
  my buddi...

• Posted in thread: Sock for grain bag? on 03-21-2013 at 10:20 PM
  Hey all,I apparently threw away all of my grain bags last week when I was organizing all of my
  brewing equipment. I switched to all grain a couple of years ago, and hadn't used them since. I
  decided t...

• Posted in thread: Sankey Coupler Clearance Question on 01-17-2013 at 01:33 PM
  Just out of curiosity, why would converting a low profile coupler to connect to your corny
  set-up be any more expensive than with a regular coupler? If you use the MFL fittings to switch
  like many peo...

• Posted in thread: Sankey Coupler Clearance Question on 01-14-2013 at 01:42 PM
  Hi all,I've got a kegerator that I typically have two cornies and a 5# CO2 tank in, and am
  looking to get a little setup going to be able to get a 1/6bbl keg of commercial beer when i'm
  out of homebre...

• Posted in thread: Whoops, kegged WAY early... on 10-08-2012 at 01:37 AM
  Well, I made a whoops. Not due to lack of patience, but stupidity... and I was a bit
  hurried.Thursday night after work, I planned on kegging a blonde ale I had finished
  dry-hopping, hopefully in time ...

• Posted in thread: Perlick Doesn't Fit on my Shanks!!! on 04-14-2012 at 01:38 AM
  had the same problem last summer when I built my draft system. Perlick was cutting their
  faucets differently and so they weren't lining up properly with the shanks. I had to hammer the
  hell out of t...

• Posted in thread: Perlick Doesn't Fit on my Shanks!!! on 04-13-2012 at 12:33 PM
  Yes, but doesn't seem to push back as far as the previous faucet... But I can tell that it's
  seated well, as the faucet won't move if I try to twist it. I tried my other shank (it's a two
  faucet tower...

• Posted in thread: Perlick Doesn't Fit on my Shanks!!! on 04-13-2012 at 03:34 AM
  The nut ring doesn't reach the threads on the faucet.