Last Activity:08-22-2015 5:25 PM
Age:2015 years old
Likes Given: 4
5 Likes on 4 Posts
Posted in thread: Crack in Bottom of Ale Pail on 08-22-2015 at 05:25 PM
Thanks all! Yeah, definitely time for a new bucket. I just wish I had a good LHBS (I'm in
Orlando) so I didn't have to pay $10 in shipping. I'll have to check out that speidel fermenter
though. I didn...
Posted in thread: Crack in Bottom of Ale Pail on 08-22-2015 at 05:03 PM
I just finished racking my IPA for secondary fermentation/dry hopping. As I was cleaning my Ale
Pail a small crack right at the base of it. I checked and it was definitely leaking (though
must have be...
Posted in thread: Carbing...Beer Line Attached? on 06-23-2015 at 11:52 PM
Set and forget!No, you don't disconnect . . .Heh...First Keg beer, I doubt I'll be "forgetting"
that anytime soon.
Posted in thread: Carbing...Beer Line Attached? on 06-23-2015 at 11:35 PM
Quick question, I'm carbonating my first beer and I had to give it a taste after about about
2.5 days. It tastes good (Woohoo!) but it tastes like it still needs a little bit more
carbonation. The hea...
Posted in thread: Kegged and Let Down... on 06-21-2015 at 06:00 PM
Here are pictures of what I saw on the "new" lid that led me to believe there's a void in the
Posted in thread: Kegged and Let Down... on 06-21-2015 at 04:18 PM
I finally solved this one. Turns out that I'm about as unlucky as they come. After many many
hours of researching and trying different things, I finally noticed a little "void" in the weld
below the n...
Posted in thread: Frusterating Keg Issue on 06-21-2015 at 04:17 PM
Ran into the same issue and this fixed it. Try unscewing the prv valve and put a thin layer all
over the rubber valve and a little inside on the threading. Screw it in hard as you can without
Posted in thread: Frusterating Keg Issue on 06-21-2015 at 03:34 PM
I'm confused about why you need a second thread for the same problem. :confused:Anyway, sounds
like it might be a bad regulator or gauge that's letting a much higher pressure through than
Posted in thread: Kegged and Let Down... on 06-21-2015 at 03:34 AM
The first lid was a pull lever, the second is a ring PRV...It has the "U" shape where it seats
fully and closes...though I did try the 90 degree thing just in case.
Posted in thread: Frusterating Keg Issue on 06-21-2015 at 03:32 AM
It was more a "I thought I had a bad lid - bought a new one, thread closed" type thing than
needing a second thread...I just thought that it might be a larger issue. How could I
troubleshoot a bad reg...