Last Activity:04-17-2013 10:30 AM
1 Likes on 1 Posts
Posted in thread: Geothermal temp control on 01-26-2013 at 02:49 PM
Why not put your fermentor in a water bath and use your geothermal system to keep the water
bath at a lower temp? What would you use to control the temp?I like that idea...one less thing
Posted in thread: Geothermal temp control on 01-25-2013 at 07:39 PM
I had an idea today. My fermentation area in the house is a little cubby behind the coat
closet/under the stairs. We mostly use it for seasonal decorations storage, but there's enough
room for a few f...
Posted in thread: Pin Lock Keg on 01-24-2013 at 01:28 AM
Cool. I won't be up there this week. I'm trying to pin down some work in DC and coordinate it
with another job I have in Germantown, MD so I don't have to make two trips. Once I get the
dates firmed u...
Posted in thread: Pin Lock Keg on 01-23-2013 at 01:29 AM
I live in Norfolk but I'll be up that way for work later this week or maybe next week...depends
on when the clients can schedule work. If you can hold onto it for a weekish I'll take it.Clint
Posted in thread: DIY grain mill in the works... on 01-06-2013 at 12:15 PM
The rim of it is bigger in diameter than my 44 qt Bayou Classic by a few inches. I'm with
jeepin...better than 30 lbs is my guess. It's a little silly how big it is, but I didn't have
to put anything ...
Posted in thread: DIY grain mill in the works... on 01-06-2013 at 02:42 AM
Almost finished. Just need to trim the plate the hopper sits on to final dimension and see if
this thing actually works. Here's a pic of it looking into the hopper/rollers.
Posted in thread: Cost of Energy Experiment on 01-05-2013 at 06:14 AM
Brewing is much less costly than flying. Safer too.:mug:Yeah, but screaming machine gun sounds
at your intended target has got to be more fun with aircraft controls in your hand vs. holding
a mash pa...
Posted in thread: DIY grain mill in the works... on 01-04-2013 at 02:37 PM
I do have a drill press and vise, and for that matter an X-Y vise I could mount on the drill
press. I also just got a 4-jaw chuck for the lathe, which should help out--I'm figuring I could
Posted in thread: DIY grain mill in the works... on 01-04-2013 at 02:29 AM
What about using round tube instead of solid bar? Something with a little thicker walls though.
And does it need to be stainless? Something with a high Rc (or Brinell if you prefer) and if
it's over 3...
Posted in thread: DIY grain mill in the works... on 01-04-2013 at 02:22 AM
I've been thinking of doing something like this as well. Just have a lathe, though, no mill, so
I might need to get creative with some of the machining. I'll be watching this one.You don't
need a mill...