Ciderguy

LATEST ACTIVITY

• Posted in thread: Advice on automated system for my brewing system on 08-09-2012 at 12:21 AM
  The propane hose actually reached the propane tank on the ground, but you can buy propane hoses
  at hardware stores. I work in a marine supply store and we sell them too.

• Posted in thread: Advice on brewing system on 06-07-2012 at 03:43 PM
  Well crap. haha, Thanks for letting me know. I should have checked in here before welding it
  all together. So even on my 2bbl system I need to keep the top of my kettles under 5 feet? I
  live in Washin...

• Posted in thread: Advice on brewing system on 06-06-2012 at 06:29 PM
  I know... when i set the new kettles in I will be lowering the top as much as I can (in fact I
  will probably need to lower the brew kettle platform too so I will be at it with my grinder for
  a while, ...

• Posted in thread: Advice on brewing system on 06-06-2012 at 04:34 PM
  Thanks! I am planning on lowering that top shelf quite a bit... hopefully that will do it! and
  short of everything else, I have a welder, and it would only cost 300-500 and about a week to
  go out and ...

• Posted in thread: Advice on brewing system on 06-05-2012 at 03:05 PM
  Thanks for the input. I keep it all in mind, and probably end up adding some more supports.
  Post some pictures when I do

• Posted in thread: Advice on brewing system on 06-05-2012 at 05:55 AM
  You seem to be knowledgeable about system building. Do you have any input. I leveled everything
  and am confident in my welds, and went with heavy gauge steel. should I absolutely put in
  diagonal suppo...

• Posted in thread: Advice on brewing system on 06-04-2012 at 10:10 PM
  I may be adding a couple diagonal supports and I used the heavier gauge steel on the whole
  system. 120mm I believe. I should be pretty sturdy.

• Posted in thread: Advice on brewing system on 06-04-2012 at 09:47 PM
  I have a 2bbl system on order. Ready for pick up in July, I understand that it looks silly with
  the keggles but it is built to the dimensions of my 2bbl system. I may need to add some
  diagonal support...

• Posted in thread: Advice on brewing system on 06-03-2012 at 04:50 AM
  I am looking at doing PID controllers. they are affordable, and they should do everything I
  need them to. I am putting together a list to order when I get paid! Once I put together a
  controller I can ...

• Posted in thread: Advice on automated system for my brewing system on 06-03-2012 at 04:47 AM
  I was just going to say I am looking into PID controllers and switches. It looks like a very
  cost efficient system that fits in my budget right now, and it should do everything I need.
  Thanks