Last Activity:02-04-2013 11:05 PM
Posted in thread: Serving Homebrew at a Wedding on 07-29-2012 at 09:46 PM
I am also brewing for a wedding and have been considering the same thing. I think I'm going to
stick with simple cobra taps. The only other idea I might do is mount my perlicks onto a board
and hold t...
Posted in thread: Don't call it a smack pack on 07-14-2012 at 01:26 AM
I've smacked 100% and never had problems. Smack it more than once if you aren't confident :)I
smack it in my hands.
Posted in thread: Suggestions for Increasing Brewhouse Efficiency? on 04-16-2012 at 11:51 PM
If you are using RO water - are you adding anything to it? Have you checked your mash pH?Adjust
your recipes to match your efficiency in the mean time.
Posted in thread: All Amarillo IPA on 12-09-2011 at 09:39 PM
Just tasted my sample when I went to keg it (4 weeks primary). Best sample I've ever had. Can't
wait for it to carb and give it a go.
Posted in thread: DIY Tumbler from Beer Bottles on 08-15-2010 at 11:43 AM
I'd like to cut the bottlom off, flip the thing upside down, and glue a base of some sort to
the neck. Nice tall goblet. Don't care too much about a tumbler.You could make the base of the
tumbler out ...
Posted in thread: Another Argument for Better Bottles on 04-23-2010 at 01:39 PM
As someone who broke a carboy, I'm glad to hear that no one was injured. Just one piece of
advice though, don't use hot water in carboys. They aren't designed for that kind of stress.hot
water is pret...
Posted in thread: $3 Weldless Kettle Bulkhead on 04-14-2010 at 06:06 PM
what kind of flux do I need to solder the SS washer to the copper? I'm assuming I can't use
regular flux, is this correct? Thanks
Posted in thread: Inexpensive way to get into a 20lb CO2 tanks on 04-05-2010 at 02:31 PM
Could use an anti-siphon tube. (Bent tube that goes inside the tank so that when the tank is in
the correct position the tube points upwards and doesn't suck in liquid that freezes the
Posted in thread: New Keezer Pics posted. on 03-29-2010 at 07:11 PM
You should mount the helmets onto the tap handles imo