VIEW MY

ccbadd

Gift Premium Subscription To ccbadd

Join Date:

08-02-2012

Last Activity:

05-18-2015 7:20 PM

Likes Given: 3

8 Likes on 5 Posts 

LATEST ACTIVITY

  • Posted in thread: The HomeBrewTalk 2015 Big Giveaway! on 04-03-2015 at 05:25 PM
    Count me in.

  • Posted in thread: Heat Sink for SSR on 02-21-2015 at 02:52 PM
    This is what I used. would definitely use a heat sink that is mounted outside of your
    enclosure.

  • Posted in thread: 11 Gal Bayou Classic eBIAB element on 01-10-2015 at 04:04 PM
    Sorry, double post.

  • Posted in thread: 11 Gal Bayou Classic eBIAB element on 01-10-2015 at 04:04 PM
    Also, I just noticed a post here were you can get weldless 2" TC connections for $40.

  • Posted in thread: 11 Gal Bayou Classic eBIAB element on 01-10-2015 at 03:47 PM
    I have a Camco 5500 watt ulwd ripple element in my BC 44qt and it works fine. I did have to
    bend it a little to get it to fit. I also have a 2" TC fitting welded to the pot which adds
    about a 1/2" or ...

  • Posted in thread: recirculating ebiab on 01-10-2015 at 03:38 PM
    Just be sure to put a ball valve on the outlet of your pump and throttle is back about half
    way. That is what works for me. Also, remember to stir your grains every few minutes at the
    beginning of the...

  • Posted in thread: Cost of 240v 30a outlet on 01-09-2015 at 12:00 AM
    If any of those 15A breakers are AFCI (not GFCI) breakers and feeding a living room, dining
    room or bedroom (any dwelling room) than you can't swap then for a double breaker unless you
    can find a doub...

  • Posted in thread: Electric Single Kettle BIAB setup. Suggestions? on 01-03-2015 at 01:16 AM
    If you are going to use a PID and not recirculate than be prepared to do a lot of stirring. I
    do wonder though if some sort of agitator would actually work better that a recirculation pump.

  • Posted in thread: How to Intall DS18B20 Probe. on 01-02-2015 at 04:23 PM
    What kind of epoxy? The probe ends from brewershardware are only $4.75 and the chip fits pretty
    snug inside it. I guess if the epoxy is rated for boiling temps and dosnt impart any flavors it
    would wo...

  • Posted in thread: How to Intall DS18B20 Probe. on 12-29-2014 at 03:17 PM
    I am using these: these:https://www.brewhardware.com/product_p/pcomp1.htmjust look for 1/4
    compression fittings and then pick what size hole you want to place it in (directly into the
    vessel or in a ...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS