Last Activity:09-05-2015 12:29 AM
Likes Given: 3
7 Likes on 7 Posts
Posted in thread: Keezer question- do I need a secondary regulator? on 01-01-2015 at 03:50 PM
Depends what types of beer you drink and how important it is to have different pressures. I
don't care too much about running different pressures and just use a standard distribution
block. If you hav...
Posted in thread: Lid Question for No-Collar Keezer on 01-01-2015 at 03:41 PM
I think people use a plywood top so they aren't ruining the freezer top in case they want to
ever turn it back into a freezer again.
Posted in thread: Forced air fridge conversion instead of chill plate? on 01-01-2015 at 03:09 PM
Tired of my chill plate modified kegerator box, it it possible to dismantle any types of old
fridges to grab the cooling unit and use it? I'm assuming this is rather difficult as I don't
Posted in thread: Chill plate freezing, why and what to do? on 01-01-2015 at 03:05 PM
It seems the fan pointed towards the chill plate make it worse? Am I nuts or could this be the
Posted in thread: Chill plate freezing, why and what to do? on 12-31-2014 at 10:04 PM
It's a edgestar kegerator that I enlarged with two layers of insulation board. I'm concerned
the door may not be 100% sealing possibly allowing too much humidity into the unit? Just
ordered a little s...
Posted in thread: Chill plate freezing, why and what to do? on 12-31-2014 at 09:01 PM
The chill plate in my expanded kegerator is a block of ice. Is this from running too long, box
not 100% sealed, both? Only keeping unit at 42F with a stc-1000.What do I do, just unplug for
an hour and...
Posted in thread: 8 cases of pop top bottles and swing tops in Ephrata area on 12-29-2014 at 01:24 PM
Looking to get rid of a ton of bottles as I've been out of the homebrew scene for a few months
and was kegging before that anyway.I have 8 cases of assorted pop tops bottles ranging from
home brew bot...
Posted in thread: Best set points for STC-1000 to minimize cycle times on large fridge? on 12-24-2014 at 05:14 PM
FWIW - I tape my probe sandwiched between a thawed ice pack and the side of a keg. Seems to
work for me and gives a much more accurate read than a bottle of water.Wouldn't it take a
really long time f...
Posted in thread: Best set points for STC-1000 to minimize cycle times on large fridge? on 12-24-2014 at 03:39 PM
I expanded the cooling area by nearly 2X on my edgestar kegerator. I can't seem to figure out
the best setting to limit compressor cycles and keep the beer at a steady temp.I found out
hanging the pro...
Posted in thread: Kegerator running for hours off for 20-30 minutes on 12-24-2014 at 03:06 PM
Did you look at the back to see the specifications? I think it should have a recommendation on
run-time expressed as a percentage.I didn't realize this was on there...difficult to see now
due to how i...