Last Activity:08-27-2016 2:42 PM
Likes Given: 27
58 Likes on 53 Posts
Posted in thread: DIY Brewjacket on 08-27-2016 at 07:10 AM
Can you share details about your peltier setup? 50 degrees is impressive - is that at the
surface of the device or in a carboy full of beer?
Posted in thread: Ultra Barrier keg beverage tubing, 3/16 X 7/16 or the silver coated stuff? on 08-20-2016 at 04:29 PM
Go with the silver - way better at not taking on odors or flavors. No issues at all with
Posted in thread: Did Blichmann Just Change Their Beer Gun Tip Design? on 08-19-2016 at 05:17 PM
I picked up one from my LHBS. Or if you order ingredients online, whoever you use may have
them.This is actually the cheapest way to buy Blichmann gear - you save on the shipping. And
you support your...
Posted in thread: Big? BIAB setup on 08-19-2016 at 05:14 PM
Well if oh get bored of using it in sure one of us will take it off your hands for you ;)
Posted in thread: Another Gatorade Cooler Mash Tun on 08-19-2016 at 06:02 AM
Are they using a galvanized nut for the inside of the cooler to hold the bulkhead for the
spigot??? Don't do that. Galvanized steel is NOT good to be in contact with any type of
foods/liquids you plan...
Posted in thread: Looking for a hose clip thingy.... on 08-19-2016 at 05:54 AM
I just spoke with and ordered a custom 1/2" SS tube bent in a J shape from Jay at NorCal. It's
still being made so I can't report on how well it works but my how is to just hang it over the
side of my...
Posted in thread: Big? BIAB setup on 08-19-2016 at 05:32 AM
Nice work! How much were you selling these for?
Posted in thread: Did Blichmann Just Change Their Beer Gun Tip Design? on 08-19-2016 at 05:28 AM
If you consider they cost less than a nickel to manufacture (Remember blichmann gets the
beergun and these tips from china theres no American manufacturer to justify the markup on this
product. ) and ...
Posted in thread: Speidel vs Agri-Mart (Pros/Cons) on 08-10-2016 at 06:01 AM
Check these accessories out for the Spiedel fermenters:
Posted in thread: Do you need a 1 off Stainless part built for your system? Let's discuss it. on 08-02-2016 at 11:42 PM
Why not? With an npt plug out would still be pressure rated as much as the kegs normally are.
Didn't realize you were thinking of a threaded fitting - it's smooth in your concept drawing.