CapnBry

LATEST ACTIVITY

• Posted in thread: Help me decide: Arduino or Raspberry Pi for brewing and smoking applications on 04-11-2013 at 02:33 PM
  It would be good to retool the PID library using a real time OS.For practical purposes you can
  usually forget about the D parameter anyway, so I'm not sure how much difference it would
  make.PIDLibrary...

• Posted in thread: Help me decide: Arduino or Raspberry Pi for brewing and smoking applications on 04-05-2013 at 01:30 PM
  I've been working on a project that has a web interface to a controller algorithm for the past
  4 years now, starting with just Arduino w/ SPI wifi and a 2MB flash addition, then moving
  through various...

• Posted in thread: Arduino Based Keezer on 04-04-2013 at 06:34 PM
  So I filled my 10lb co2, connected everything, and the regulator said the tank only had 700 psi
  (60% on the outer gauge). I ran a keg of water + cleaner through everything, and then a keg of
  just wate...

• Posted in thread: Arduino Based Keezer on 04-02-2013 at 08:00 PM
  Sure, emperorcow, the code to my flow meter is in github these Flexiforce pressure sensors

• Posted in thread: Arduino Based Keezer on 04-02-2013 at 07:27 PM
  I've used the same flow meters in a recent project to measure my sparge rates and
  volumes:https://lh5.googleusercontent.com/-xwevX9fwlDc/UTuvwo7DGzI/AAAAAAAABDQ/BSllWhuzJG4/s640
  /IMG_1491.JPGIf you don...

• Posted in thread: Flow sensor for electric brewery on 03-10-2013 at 02:41 PM
  I have a problem. When I look at my brewery I think that if it is working, then it doesn't have
  enough features. Certain parts of the brewing process suggest specific liquid flow rates, but
  without in...

• Posted in thread: Digital temperature probe thoughts on 03-10-2013 at 02:08 PM
  I use RJ-11 phone cord because they're easy and securely snap in and I have plenty of old phone
  cords around to cut a end off of. I'm told you can also splitters and daisy chain multiple
  sensors toget...

• Posted in thread: Kitchen Friendly Keezer Build (GE 7.0 Model # FCM7SUWW) on 03-09-2013 at 11:23 AM
  I would pay attention to the shanks and make sure that you don’t have too much extra hanging
  off inside. I have 5 1/8” and I found that it makes it hard to get the front kegs out.++to
  this. I used 2x...

• Posted in thread: Fitting 4kegs into a GE 7.0 fcm7suww Keezer (Cutting Corny Keg rubber?) on 02-28-2013 at 02:08 AM
  I have the GE 7.0cf model from Home Depot and just came back from trying to fit 4 ball lock
  kegs in it. They're in there so tight that I can almost lift the freezer trying to pull a keg
  out. I tried w...

• Posted in thread: Frigidaire 14cu foot upright freezer - coils in walls? on 02-05-2013 at 07:46 PM
  I have the 13.7cf version of this, which looks nearly identical except for all my shelves are
  wire rack and fixed. The cooling coils are all built into the back (as they are with any
  self-defrosting f...