Gift Premium Subscription To Buzzy

Join Date:


Last Activity:

10-09-2014 3:53 PM


  • Belleville Mi
  • Family,Drag Racing,Beer,.....
  • Test tech
  • Rock, Blues, Jazz....
  • NHRA Drag Racing, and some stuff on the Discovery Channel
  • New to brewing. Starting with an extract kit.


  • Posted in thread: what gauge steel tube for brew stand on 02-21-2011 at 02:33 AM
    I myself would go with the 1/8" wall tube. It will weld much easier and and have much more
    strength. When in doubt.... build it stout. You will probably have this for a long time. Also
    if you move it ...

  • Posted in thread: Help with propane burners! on 10-20-2009 at 01:25 AM
    I had the same problem. The 1/8" fitting going into the burner was flowing way to much volume
    of propane. I took JB weld and filled the 1/8" nipple full. Then I took a 0.030" drill and
    drilled a hole ...

  • Posted in thread: Does my drill suck? on 10-14-2009 at 03:14 AM
    I lay out a hole with some dividers than I use my plasma cutter to rough out the hole. I follow
    behind with carbide burr and grind to the line. I know alot of people out there don't have
    these tools b...

  • Posted in thread: Always the wrong place wrong time on 10-01-2009 at 12:28 AM
    Probably some guy bought them to put change into them.

  • Posted in thread: Plastic bag for Must on 09-25-2009 at 10:00 PM
    I just purchased a new garbage can to grind my grapes into. I hear that plastic cans with HDPE
    stamped are acceptable to store the must. The can I have has PP stamped on it. Is there a bag
    or a liner ...

  • Posted in thread: Paint for wine press?? on 09-21-2009 at 10:11 PM
    Well I wont be powder coating the press....They want $205.00 to do it! Ouch. Help me out here.
    What paint can I use?

  • Posted in thread: Paint for wine press?? on 09-20-2009 at 04:14 PM
    Any thoughts on having it powder coated?

  • Posted in thread: Small Batch Questions on 09-20-2009 at 12:47 AM
    Good luck with the cider. I might give this one a try too. Its easy enough!!

  • Posted in thread: Paint for wine press?? on 09-20-2009 at 12:35 AM
    Well I bought this old wine press and I started to clean it up. It had a thick sticky sludge
    all over the cast base. I started scrubbing it up and found that this sludge has caused the
    paint on the ca...

  • Posted in thread: Wine press and grinder cleaning. on 09-17-2009 at 12:57 AM
    As far as the press goes just some good ole scrubbing and if its really caked on then a wire
    brush on the metal. You should get it pretty clean and a k-meta/citric acid pray down before
    use is a "must...