VIEW MY

burbelly

Gift Premium Subscription To burbelly

Join Date:

02-01-2011

Last Activity:

12-08-2013 7:34 AM

1 Likes on 1 Posts 

    ABOUT ME

  • Single
  • miami
  • fl

LATEST ACTIVITY

  • Posted in thread: Resetting Refrigerator/freezer Thermostat for normal operation on 11-24-2013 at 06:37 PM
    I have been using my fridge/freezer for fermenting but now I want to revert it back to normal
    use. What position should I set the dial to for recalibrating? IE: I imagine I should put the
    capillary tu...

  • Posted in thread: No precipitation in starter on 09-27-2013 at 05:51 PM
    I have had my starter going for about 24 hours now on the stir plate and I can't observe any
    precipitation when I stop it for 5 min. This is the first time I use a stir plate. Is this
    normal?Edit: saw...

  • Posted in thread: New Stand with CIP on 05-23-2013 at 07:42 AM
    Here's my new stand complete with a pump that I got for free from my cousin (THANKS!). It's a
    nice step up from a wire shelving rack on cinder blocks. The drain assembly can be removed to
    clean out an...

  • Posted in thread: couplers,secondary regs,cold plate on 05-10-2011 at 02:01 AM
    Received today. Thank you for the fast shipping!

  • Posted in thread: couplers,secondary regs,cold plate on 05-05-2011 at 11:59 AM
    I'll take both secondaries if they are still available.

  • Posted in thread: Austins hydrometer calibrated @ 155 on 05-03-2011 at 09:34 PM
    I just saw it. It's on my list of thinks to buy next.

  • Posted in thread: Solder Flange of element? on 05-02-2011 at 06:05 PM
    It's zinc plated carbon steel for those who would like to know.

  • Posted in thread: Solder Flange of element? on 05-02-2011 at 02:55 PM
    A rod with a hook can be slipped into the clamp knob that is upright and spun off. As to the
    danger, by the time I'm whirlpooling, I'm done with the heat and disconnect it. As with any
    electrical syst...

  • Posted in thread: Solder Flange of element? on 05-02-2011 at 02:44 PM
    Whirlpooling

  • Posted in thread: Solder Flange of element? on 05-02-2011 at 01:35 PM
    This would give me the shortest package for a pseudo airlock configuration that would allow me
    to disconnect the power leads, put on a tri clamp cap, and remove the element while the vessel
    is full.

0 COMMENTS
POST A COMMENT