Gift Premium Subscription To BuckyBrewing

Join Date:


Last Activity:

10-13-2010 10:46 AM


  • Male
  • Married


  • Posted in thread: Guinness keg disassembly? on 10-22-2009 at 11:05 PM
    From the pic it looks very similar to a Miller keg (see I had no luck with the safety catch
    (and I didn't care about a perfectly round hole in the lid) so I ended up drilling a starter
    hole with a b...

  • Posted in thread: this guy oens BeerPong on 10-22-2009 at 04:04 PM
    My guess it is fake. This video was around youtube for a while but I think that someone made it
    with microsoft's video editing tool.[ame=" n Slide[/ame]

  • Posted in thread: Rust on my Heating Element on 10-09-2009 at 02:17 AM
    wilserbrewer it is not wort residue. i was just boiling water to make sure it was working
    properly. Now I am a little tentative on using this element bcs of the rust. I will try to use
    the barkeeper's...

  • Posted in thread: Rust on my Heating Element on 10-09-2009 at 01:39 AM
    OK I was going to start working on my 2nd electric kettle and took apart the first one so I can
    take some measurements of the cable lengths then I noticed something. My water heater element
    rusted whe...

  • Added a new Photo on 10/09/2009

  • Posted in thread: Cable Lengths on 10-02-2009 at 12:55 AM
    Pol, you make a good point. I was just seeing if people had any suggestions before I went
    through the trouble of making the cables.

  • Posted in thread: Cable Lengths on 10-01-2009 at 10:44 PM
    my controller will only be near my kegs so I am thinking that 6 ft will be enough at first but
    when I finally attached the cord to the element it just seemed so short that I was a little
    concerned. I ...

  • Posted in thread: Cable Lengths on 10-01-2009 at 03:45 AM
    For all of the people who are using electric water heater elements on their kettles, what is
    the length of the cable you used? I was originally thinking 6 feet, however I think that this
    maybe too sho...

  • Posted in thread: What's your occupation: Engineer or Non-Engineer on 10-01-2009 at 12:44 AM
    Mechanical Engineer'98 University of Wisconsin - Madison

  • Posted in thread: Greetings from the Buckeye State on 09-30-2009 at 12:33 AM
    Welcome, nice to see another person from Ohio here.