Last Activity:11-28-2015 3:23 AM
Likes Given: 7
4 Likes on 4 Posts
Posted in thread: FastFerment conical on 11-13-2015 at 02:31 AM
I want to add to the praise....I sent an email to them questioning the gaskets, and received 2
new ones for free....how can you beat that!!I do have a question for all users of the
Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 11-11-2015 at 10:54 PM
That's what I was thinking
Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 11-11-2015 at 07:40 PM
Guys, I have a strange predicament that I was hoping you could help me out with.Today, my SD
card became corrupt after I hot swapped my USB Wifi dongle. I had to reload BrewPi entirely.
Once that fini...
Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 11-10-2015 at 05:46 PM
Posted in thread: How To: BrewPi LCD Add-On on 11-09-2015 at 06:48 PM
So, not being able to determine where the short was I decided to try again with new components.
During the test I noticed the display scramble when the keezer compressor kicked on. I grabbed
a 2.2uf 1...
Posted in thread: How To: BrewPi LCD Add-On on 11-07-2015 at 05:00 PM
Now the led on the UNO will start to fliker rapidly during burn in. It will function normally
for 15, 20 minutes. When is normal I have 5 VDC on my output. Then when it fails the voltage
Posted in thread: How To: BrewPi LCD Add-On on 11-07-2015 at 02:07 PM
I double checked my connections, and sure enough I had a bad connection to the ground buss. Now
I have a working encoder. Which occasionally scrambles the display. But it's progress. Thanks
for your h...
Posted in thread: How To: BrewPi LCD Add-On on 11-06-2015 at 11:43 PM
I used the caps on the encoder switch and encoder wires. between them and ground. Without the
pullups indicated on your drawing. And connected the 5vdc and ground directly to the encoder
board. I'm go...
Posted in thread: How To: BrewPi LCD Add-On on 11-06-2015 at 10:04 PM
i bought these rotary encoders on ebay. they already have 10k resistors on themRotary Encoder
Module Brick Sensor Development Board For Arduino #100NEW the same encoder I bought. I
assumed that sinc...
Posted in thread: Russian Imperial Stout (2011 HBT Competition Category Winner) on 10-29-2015 at 11:02 PM
So, if i have a 1/2 pack of yeast, would i just cut things in 1/2?Just make a small container
of wort. About 1 or 2 quarts at 1.040 SG. Use a light DME. Since you probably don't have a stir
plate you ...