Last Activity:02-01-2015 1:05 AM
5 Likes on 5 Posts
Posted in thread: Plastic 1/6 bbl pub kegs- anyone tried em? on 09-08-2014 at 01:22 AM
Has anyone used these as fermenters?I dont see why it would be a problem. Just make sure the
sanke tap is sterile and use a spunding valve or blow off tube. Might be a good time to check
out the press...
Posted in thread: Yeast immobilization: magic beans of fermentation on 09-24-2013 at 01:19 AM
Posted in thread: Plastic 1/6 bbl pub kegs- anyone tried em? on 08-27-2013 at 11:07 AM
You could probably leave off the outer shell if you were looking to save space in the keezer.
Posted in thread: Plastic 1/6 bbl pub kegs- anyone tried em? on 07-22-2013 at 02:01 AM
Just something to consider... Looks like Redhook wasn't an isolated incident and has occurred
while cleaning the kegs as well. consider looking at other avenues for stainless. U said u got
three for ...
Posted in thread: Plastic 1/6 bbl pub kegs- anyone tried em? on 07-21-2013 at 05:13 PM
I think Pubkegs are good up to 60psi so you can do whatever you normally do to carb.edit:
Confirmed 60 PSI at mfg website.
Posted in thread: Plastic 1/6 bbl pub kegs- anyone tried em? on 07-21-2013 at 01:41 AM
So how are you guys carbing up via CO2? Or are you just using priming sugar and using CO2 to
push the beerI usually use co2 to carb.
Posted in thread: Heat Stick questions on 07-18-2013 at 07:11 PM
You can control the heat stick with a raspberry pi. They are cheap and DougEdey wrote a web
based app already. Check out
Posted in thread: Plastic 1/6 bbl pub kegs- anyone tried em? on 07-18-2013 at 01:31 AM
I havent used one 10 times yet (I purchased 10 and have only used a few of those so far), but
since they were used I did see some beerstone build up. The good news it is really easy to any
Posted in thread: Plastic 1/6 bbl pub kegs- anyone tried em? on 07-17-2013 at 10:37 PM
I have been using them for about 6 months and I am very happy so far. The sanke spear unscrews
and gives you a 2" opening to fill/clean the keg. You can buy them new here but I would check
for used ...
Posted in thread: StrangeBrew Elsinore - Raspberry Pi based brewery controller on 07-16-2013 at 12:33 PM
Check out page 5 of this thread and read on. Then make sure your Raspberry Pi is configured as
a LAMP server. To do this I installed Wheezy then ran the following commands from a