bohdan987

LATEST ACTIVITY

• Posted in thread: Project "WOODY 3.0XPR" worlds first wooden, adjustable, 3 roller grain mill on 01-01-2013 at 11:43 AM
  hi guys, yes its been a while. Rollers are holding up fine, just a regular wear and tear on
  them nothing major.

• Posted in thread: March Pump Switch Box - DIY on 12-07-2011 at 03:05 PM
  Goose: multiple homebrews at 6 oclock.looks good.

• Posted in thread: ooooh noooo! on 09-22-2011 at 08:34 AM
  it will be fine, don't worry. good thing that you sanitized both.

• Posted in thread: Glycol Pump for a 12 foot rise from basement keezer to living room tap? on 09-22-2011 at 08:28 AM
  pump chilled salt water through the old glycol lines(made of copper).Thanks :mug:salt water and
  copper(almoust any metal) don't mix well. Copper will corode after a wile and salt will eat
  thru the pip...

• Posted in thread: Condition Dark Malt prior to milling? on 09-09-2011 at 08:14 PM
  i just mill my grain newer do any conditioning.

• Posted in thread: Chiller in HERMS on 09-09-2011 at 07:28 PM
  yes, you can.

• Posted in thread: My HERMS Control Box (Auber 2362) on 09-06-2011 at 04:17 PM
  looks good and clean. take your time and do it right the first time.

• Posted in thread: Paintball regulator problem on 07-28-2011 at 11:29 PM
  sounds like a regulator is leaking bypassing adjastment setting.if the 0-ring was leaking on
  the tank, he would loose co2. 0-ring on the tank has nothing to do with his problem. i was
  thinking that th...

• Posted in thread: Keezer question on 07-28-2011 at 09:13 PM
  you need to use a mechanichal fastener AKA ckrew and liquid nails. since you have to land
  straight on the "bottom" so you get a nice seal, liquid nails don't like the cold. wood is not
  straight it alw...

• Posted in thread: Best approach to cut slots in manifold on 07-28-2011 at 08:54 PM
  i think the best way to do this jub is a reciprocating saw with a new thin metal blade. start
  the saw before you start cuting than lower that blade on the mark with out stoping. after you
  reached your...