Blueskew

LATEST ACTIVITY

• Posted in thread: Portable igloo cooler kegerator on 08-02-2011 at 01:35 PM
  I bought my paintball reg through kegconnection and that reg has worked just fine for me. I've
  pushed more than 30 gallons on one fill (I think I'm using 20 oz tanks) and haven't had to
  switch to the ...

• Posted in thread: Three Points of Failure on 06-21-2011 at 07:00 PM
  Happyvdubber,This was actually my first 10 gallon batch, but the early addition could certainly
  do it. I'll cut it down to 5-10 minutes before the end of the boil next time and see how things
  go. Just...

• Posted in thread: Three Points of Failure on 06-21-2011 at 02:41 PM
  Happyvdubber,Just one tablet.Everyone,Ok, thanks for the heads up about the cold break. I don't
  know why, but I've never gotten cold break before. Or at least I've never seen it kick up like
  this so I...

• Posted in thread: Three Points of Failure on 06-21-2011 at 12:55 PM
  Hi guys. I had a weird night brewing last night where I either screwed up or tried new things
  three times and I'm wondering if someone can tell me what I have going on here. I'm just doing
  a light cre...

• Posted in thread: Portable igloo cooler kegerator on 06-20-2011 at 06:51 PM
  BBBF,I had the same question and problem, but mine is (semi) permanently attached. Luckily, the
  cooler fits in the backseat, but turned sideways (sidewall against the seat). On top of that, I
  put my s...

• Posted in thread: Portable igloo cooler kegerator on 06-20-2011 at 03:48 PM
  Gryphon,I've had good luck transporting my beer and having it be extremely clean and drinkable
  immediately. However, I always use a secondary fermenter and have very little sediment in my
  kegs as a re...

• Posted in thread: Portable igloo cooler kegerator on 06-20-2011 at 03:40 PM
  Ok, final shots now that the portable kegerator has been used 3+ times:Drip tray (10" with 2"
  splashback). manifold closeup (2 switch manifold running to outside of cooler with 2 3/8"
  barbs on a 2" l...

• Posted in thread: Portable igloo cooler kegerator on 06-10-2011 at 02:19 PM
  Vongo,I followed the same approach as outlined by Whutever. I used a 2" long x 3/8" nipple with
  two 3/8" x 3/8" barb ends. I don't actually have that in my current pictures, but I'll upload
  now that I...

• Posted in thread: Portable igloo cooler kegerator on 05-24-2011 at 04:36 AM
  Well, the major parts are complete. I haven't hooked up the manifold yet because I don't have
  my paintball canisters full yet, so I'm using my 5 pound tank instead. Still trying to figure
  out the corr...

• Posted in thread: Portable igloo cooler kegerator on 05-23-2011 at 10:34 PM
  Ok, the parts are all in and I hope to start building (and hopefully finish) by tonight. I did
  have a question about the original post. 10' 3/16" ID tubing2 - 4 1/2" faucet shanks with 1/4"
  tail piece...