Last Activity:10-05-2012 8:20 AM
2 Likes on 2 Posts
Posted in thread: Might be selling a bunch of gear motors, could work great for grain mills on 09-28-2011 at 10:55 PM
DerfBrew I'm in La Pine and in Bend a few times a week if you guys want to sell.
Posted in thread: Chest freezer heater on 09-27-2011 at 05:55 PM
I use a reptile heater pad in my 8.8cuft Kenmore. It's a 16 watt model and with my utility room
at 40 degrees the heater keeps my temperature up to 68 with no problem. Best yet it only uses
16 watts! ...
Posted in thread: How much beer is left in the keg?? on 07-12-2011 at 08:34 PM
I use a tally sheet that is on a clip board by me keezer. When someone pulls a pint we make a
mark. With the glasses I have usually I get about 40 or a little more pours and it kicks. This
Posted in thread: Condensation on 06-23-2011 at 07:03 PM
I put 3 or 4 yellow micro fiber towels from Costco in the lower corners of mine. Every time I
change out something I take out the towels to dry and add fresh ones. I also use these in my
keezer with g...
Posted in thread: show us all your fermentation closets/chambers here on 06-23-2011 at 03:29 PM
I like my keezer so much that I built this setup for fermenting. I did the same double hinge
setup as my keezer, so the lid or entire collar can be lifted separately. With the collar I can
get a carbo...
Posted in thread: Bayou Classic SQ14 lift kit on 06-23-2011 at 02:58 PM
I did the pipe deal on mine for awhile, used 2" black iron pipe over the legs. It's really
scary watching 10 gallons of boiling liquid move around without anyone touching the keggle.
Just could never ...
Posted in thread: Bayou Classic SQ14 lift kit on 06-22-2011 at 04:53 PM
Decided to lift up my SQ14 burner, so I welded some legs to it. Turned out so good I might try
selling this setup someday. I used 3/16 x 2 angle, probably could go with lighter steel next
time but the...
Posted in thread: DIY Beer Chalkboard on 06-18-2011 at 06:30 PM
Nice job on the chalkboard MW66. I made one up myself awhile back. Put a oak frame around mine
and used a piece of birch plywood I had laying around with chalkboard paint. While I was
drinking some br...
Posted in thread: Monster Mill using hand crank? on 06-07-2011 at 11:47 PM
My drill works pretty hard to turn my MM-3, no way I would want to crank it. You can get a
Harbor Freight 1/2" slow speed drill for less than $40.
Posted in thread: Centennial Blonde (Simple 4% All Grain, 5 & 10 Gall) on 06-01-2011 at 10:04 PM
I have my 3rd batch cooking right now and I'm having a pint of my