Last Activity:04-18-2014 1:42 AM
Likes Given: 1
2 Likes on 2 Posts
Posted in thread: Wort Monster Giveaway on 04-16-2014 at 11:36 PM
Posted in thread: Finally got my motorized mill on 03-22-2014 at 07:17 PM
Threw this together in about 45 minutes very simple to wire and adjust.Got a motor off ebay
~$40 ge 177 rpm Lovejoy connections L070 1/2" for the motor and 3/8" for the Barley Crusher.
(Amazon)20 mfd ...
Posted in thread: Brutus Build # pick one on 03-22-2014 at 07:03 PM
Also added on a new SS sparge arm with a union for each detachment.
Posted in thread: Brutus Build # pick one on 03-22-2014 at 07:01 PM
Did some more up grades! My buddy has access to a laser etcher so he did all the labels on the
panel for me that way and threw on some hops to class is up a bit. Looks great, works great.
Posted in thread: HomeBrewTalk 2014 Big Giveaway on 02-18-2014 at 01:28 AM
Big beer for me!
Posted in thread: Brutus Build # pick one on 01-23-2014 at 04:34 AM
Controller upgrade inspired by The Electric Brewery, thanks Kal. XLR QD's for 2 rtd probe,
electronic float valve to control water solenoid for HLT, and the power supply for the gas
Posted in thread: Auberins RTD Sensor on 12-16-2013 at 02:04 PM
I bought 10K ntc's from Digikey. 10 for $21 and are +/-1% tolerance.Epcos, B57861S0103F040
love controller are you using? I have the ts2 which gives 1k ohm ptc in the specs but doesnt
give the ntc sp...
Posted in thread: Auberins RTD Sensor on 12-15-2013 at 09:19 PM
did you use a 10k ohm ntc thermistor? I tried to get the same one via pictures but I ended up
getting a 100k ohm
Posted in thread: Auberins RTD Sensor on 11-20-2013 at 11:52 AM
I have a few auber RTDs that I converted to thermistors because I switched over to a BCS.
However, this won't work for a brewtroller setup because those sensors are much larger than a
thermistor or RT...
Posted in thread: Drill Powered Grain Mill Setup on 09-04-2013 at 01:32 AM
Rustym.... how did you mount the drill?