Gift Premium Subscription To badmojo

Join Date:


Last Activity:

10-29-2016 11:54 AM

Likes Given: 1


  • Rochester, MN
  • Otolaryngology resident
  • Male
  • Married


  • Posted in thread: Element housing - a novel method? on 01-12-2013 at 02:21 AM
    I did think about various different PVC/conduit elbow type options, but could never find a way
    to reliably ground it and attach the wires inside without them getting all twisted up.
    Certainly there ar...

  • Posted in thread: Element housing - a novel method? on 12-30-2012 at 09:35 PM
    I would confirm this first.. I dont have one in hand, but im almost positive it is not a pipe
    thread (much finer, higher pitch)I don't have anything to back that up. I do know that the
    particular unio...

  • Posted in thread: Element housing - a novel method? on 12-30-2012 at 09:25 PM
    All the sharing of knowledge and inspirational builds have been instrumental in the building of
    my eHERMS brewery. I thought I'd contribute a little something - my element housing.I think
    it's a melan...

  • Posted in thread: Troubleshooting help on 12-29-2011 at 06:53 PM
    Just wanted to quickly add to this discussion. My setup is a Kal-inspired control panel (though
    customized/simplified), and I had installed a Square D 30A 240V double pole GFCI breaker
    (QO230GFI). I w...

  • Posted in thread: Can I do this? on 12-14-2011 at 04:03 AM
    ...also switching the thermocouple of course.Is it a thermocouple or an RTD? Apparently you
    need to be careful about what type of wire you extend/switch a thermocouple with, as its
    sensing is based on...

  • Posted in thread: 2P-Twent-E: the new Brouwerij Boerderij Kabouter on 12-10-2011 at 10:51 PM
    Long time lurker, first time poster. This piqued my interest, as it relates to my upcoming
    electric build. I've been looking to switch between two sensors, as well (RTDs). I don't see
    why it wouldn't ...