VIEW MY

atomicjoe23

Gift Premium Subscription To atomicjoe23

Join Date:

01-30-2007

Last Activity:

07-15-2015 10:47 PM

1 Likes on 1 Posts 

LATEST ACTIVITY

  • Posted in thread: Fermenter/Brite Tank cooling coils??? on 07-15-2015 at 10:47 PM
    Anyone know what size coils/how many would be reasonable to cool 5 BBL fermenters/brite
    tanks???I've got two stainless 5 BBL brite tanks and 2 3 BBL cylindroconical fermenters that
    aren't jacketed. I'...

  • Posted in thread: What is a beer/oxygen/carb stone??? on 12-17-2013 at 06:45 AM
    I understand what it does (to an extent). . .what I would like to know is what are they made
    out of and/or where can you get the raw stone without any fitting already attached to
    it.Thanks!

  • Posted in thread: Where to get plastic 4.5 gallon beer pins??? on 06-15-2013 at 05:28 PM
    Anyone know where to get 4.5 gallon plastic beer pins???Like this, individually.Thanks.

  • Posted in thread: Horizontal vs. Vertical MLT. . .Pro's & Con's??? on 11-20-2012 at 09:12 PM
    Thanks guys. . .. . .good point LuiInIdaho; I had not thought of that and probably wouldn't
    have though of it until someone else pointed it out and I felt like a dumy.Greatly appreciated.
    . .looks lik...

  • Posted in thread: Horizontal vs. Vertical MLT. . .Pro's & Con's??? on 11-20-2012 at 05:49 PM
    I am getting ready to step up to all grain brewing and I'm planning my brewing system out now.
    I have 3 15.5 gallon sanke kegs that I plan on converting, but I was curious as to whether
    there was any ...

  • Posted in thread: Motor size (HP) for grain mill? on 03-14-2012 at 01:45 AM
    No I had not. . .buy thanks for the tip, that could save quite a bit of time. . .greatly
    appreciated!

  • Posted in thread: Motor size (HP) for grain mill? on 03-13-2012 at 02:43 AM
    Tried out the smaller knurls on the replacement rollers I made for their Barley Crusher and the
    little knurls didn't work. . .so I'm making a cut knurling tool to be able to cut the deep
    aggressive kn...

  • Posted in thread: Motor size (HP) for grain mill? on 02-23-2012 at 01:01 AM
    Yes it will be adjustable and gear driven. . .spur gears don't fully bottom out when they mate
    with each other (at least they aren't supposed to. . .there is one that does, but I'm not using
    that type...

  • Posted in thread: Motor size (HP) for grain mill? on 02-22-2012 at 05:15 AM
    @RMullins. . .yes that would work, ideally I would use a reduction coupling similar to that as
    well, but since I'm doing this out of my pocket for them I'm not going that route. . .yet.

  • Posted in thread: Motor size (HP) for grain mill? on 02-22-2012 at 05:14 AM
    I have a question. You say that you will mill 50lb at a time. Will you be using that amount in
    less than 2 weeks?Milled grain goes stale/loses it's freshness much faster than whole grain. I
    mill only ...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS