Last Activity:03-25-2015 10:00 PM
1 Likes on 1 Posts
Posted in thread: Fermentation Chamber built with window A/C unit on 03-28-2012 at 11:42 PM
[quote=kbrtny;2958587]I'm actually doing a super simple controller for my first version. I am
using an MSP430G2231 with a built in temp sensor, a basic relay driver chip, and a 12v relay to
bypass my ...
Posted in thread: Wood Brutus 10 on 03-27-2012 at 01:15 AM
I just bought the low pressure orifices. They were $7 a piece at Brewer's Hardware. ( read a
lot of post about drilling them out. Since I didn't have the right drill bit I figured by the
Posted in thread: Wood Brutus 10 on 03-25-2012 at 01:07 AM
Well after nearly 3 months waiting my burners arrived! Installed them this weekend and hooked
up the gas valves. Now to start working on the running wire and building my control panel.
Posted in thread: Wood Brutus 10 on 02-12-2012 at 01:11 AM
New update: Put together my gas manifold. set it in place but not attached yet. Still waiting
for my burner from Agri-Supply...ordered in December and then they went back order...were
supposed to be h...
Posted in thread: Wood Brutus 10 on 01-04-2012 at 04:18 AM
My previous stand is wood too. No issues with scorching. My current design and old one utilizes
an air gap and I find this works very well. The only concern I have is my banjo burners I have
on order ...
Posted in thread: One stop shop tutorial for automated propane? on 01-01-2012 at 05:37 PM
Here you go. I drew this up for you this morning. The VR8200A is $50 on Ebay and you can find
the Q314A for $7.00. You do not need an SSR. You will need a PID controller, 24 volt
transformer and RTD (...
Posted in thread: Wood Brutus 10 on 11-18-2011 at 09:27 PM
I've seen it in Home depot and Lowes for the sheet steal. I'm planning on cutting hole in the
bottom in the diameter of the burners and then attaching with L-brackets. The burners will be
Posted in thread: Wood Brutus 10 on 11-17-2011 at 11:36 PM
A minor update. Installed the cross members to support the keggles. Up next is to buy my
burners...thanks everyone for the advice. I am going to go with the 10" banjo's for all of
them. Here are a cou...
Posted in thread: Tsar Bomba Russian Imperial Stout on 10-29-2011 at 07:30 PM
LBOZMALT OR FERMENTABLE108 Pale Malt (Maris Otter)20 Crystal 40L18 Briess Munich Malt14
American Chocolate10 Flaked Barley04 Black Patent MaltAdd two Madagascar vanilla beans, split
lengthwise and scr...
Posted in thread: Wood Brutus 10 on 10-29-2011 at 02:54 PM
I plan on mounting the burners to the basin using L-brackets. That basin is some pretty stout
stuff. I plan on using black iron pipe as the gas line which will also provide some support.
I'll have to ...