- Posts 18
Last Activity:05-22-2015 6:11 AM
1 Likes on 1 Posts
Posted in thread: Help me figure out if I have a leak in my kegging system... on 12-30-2014 at 01:14 PM
The easiest way I have found where a leak is the following;Connect the regulator to the tank,
Open the tank and set the regulator low pressure side to 10-15 psi. Don't connect any gas lines
to your ke...
Posted in thread: Root beer doesn't taste like wort on 10-10-2014 at 01:31 PM
If you aren't adding sugar post fermentation the change in flavor is the yeast consuming the
sugar in the wort. Beer is the same the wort pre-fermentation is sweet but after it's fermented
a lot of th...
Posted in thread: Helical Coil HEX Design on 07-30-2014 at 01:03 PM
As far as efficiency goes nothing beats a CFC either in tube or plate form.The leg that returns
at the end of the coil will reduce your efficiency. If you ran your coil in one end and out the
Posted in thread: Hello from Quispamsis, NB Canada on 07-19-2014 at 01:33 PM
Hey there, in Quispamsis too!I've been doing AG for about 2 years and have kegged for about 10.
Send me a PM.Look up Fundy Area Brewers on Facebook.
Posted in thread: Closet kegerator conversion. on 06-23-2014 at 03:07 PM
You could use a window AC unit to cool an insulated closet. Similar idea to a walk in cooler.
Posted in thread: Craft beer in Nova Scotia on 06-19-2014 at 12:52 PM
is the Nova Scotia Liquor Commission website listing of beers.
Posted in thread: Hello from Saint John, NB Canada on 06-02-2014 at 10:57 AM
Hi there from Quispamsis.
Posted in thread: Hello from NB Canada on 09-18-2013 at 10:50 AM
You did not mention where in NB you are. If you are around Saint John, look up Fundy Area
Brewers on facebook. There is another club in Fredericton, called NB Craft Brewers.
Posted in thread: 1 out of 5 kegs has foamy pour on 08-22-2013 at 10:47 AM
Also if the dip tube is too long it will touch the bottom and cause a restriction
Posted in thread: My 60 amp Kal mutation on 07-24-2013 at 11:58 AM
I have one of these units. A 6500W rated one for a 4500W element.Yes you run both hot legs
into/out of the unit.