Last Activity:01-08-2011 9:24 PM
1 Likes on 1 Posts
Posted in thread: Vinator Bottle Rinser can you use starsan? on 10-22-2010 at 07:01 AM
Will starsan foam too much with this???Vinator Bottle Rinser
Posted in thread: how strong is 1/8" plexi-glass? on 10-21-2010 at 10:51 PM
Sorry, here is a little more about the chamber I am going to build.It will have a 2x2 perimeter
frame with 3 2x2s across it. Then it will have a 1/2" plywood bottom, and a 1" (or 2 inch, not
Posted in thread: how strong is 1/8" plexi-glass? on 10-21-2010 at 08:45 PM
I am looking to build a fermentation chamber and found a really good deal on this. I was going
to use this acrylic (plexi-glass) as the inside bottom over my insulation board so that it
would be easy ...
Posted in thread: Paying it Forward - motobrewer on 10-01-2010 at 10:02 PM
Posted in thread: is a two hour mash too long? on 06-04-2010 at 08:19 PM
I finally have time to brew this weekend, kind of. I have a soccer game in the middle of a six
hour gap. Can I mash for the 2 hours I am at the soccer game, then finish the brew day when I
Posted in thread: 2 sanke kegs for sale in So Cal 92831 on 06-04-2010 at 05:24 AM
Guess I should have put a price, LOL. I would like $40 each, or best offer. What do you have to
trade?I would love a plate chiller, corney kegs, jockey box, fermentation chamber, or???
Posted in thread: How much does 2000lbs of grain cost? on 04-21-2010 at 10:25 PM
Ok, I meant for 2 row. And where I get it from? The cheapest place, like LHBS do. It must be
below 70cents too. I can get it for 60cents from my LHBS.
Posted in thread: How much does 2000lbs of grain cost? on 04-21-2010 at 10:01 PM
Does anyone know? I have about 10 people to split grain with. how much does a 2,000lb pallet
cost? That is the amount that BULK comes in right?
Posted in thread: Using a step bit on 04-19-2010 at 03:47 PM
So, I am trying to drill a hole in my keg with a step bit. These are the $10 step bits from
harbor freight. The first 3 steps went fine, but now I am at about 1/2 inch and it doesnt cut.
It just spins...