VIEW MY

Alt

Gift Premium Subscription To Alt

Join Date:

07-13-2013

Last Activity:

12-02-2016 7:01 AM

Likes Given: 4

5 Likes on 5 Posts 

    ABOUT ME

  • Pale Ale from Heretic Brewing wort collected at AHA rally with added Amarillo dry hops
  • American Brown Ale
  • Male
  • Single
  • Santa Rosa
  • CA

LATEST ACTIVITY

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-26-2016 at 07:11 AM
    @Ph03n1X1:Try switching your relays to GPIOs 9 thru 26 on the Pi and see if the relays start in
    their 'on' state. GPIOs 2 thru 8 default to a high pull up at power-on reset of the Pi. When
    the GPIOs a...

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-26-2016 at 05:49 AM
    @ame:Are you using a board with the blue Songle relays or one with the dark grey Omron relays?

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-23-2016 at 03:14 PM
    @ame:Simple solution, good to know. Should work for CBP too as long as it doesn't force GPIO to
    active high within its own code, something to test later this weekend. Thanks!

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-23-2016 at 07:15 AM
    Here's a simple circuit that will allow the Pi's GPIO to pull the Sainsmart inputs low for
    proper operation.378034

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-23-2016 at 05:54 AM
    It does not defeat the purpose of the SSR at all as the purpose of the SSR is to switch the
    220v (which has too much current for the relay board). The relay board is just providing
    switching to the po...

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-23-2016 at 02:37 AM
    Here's the one you want:

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-22-2016 at 09:10 PM
    Generally yes, but that is a momentary contact, double throw switch. Try a continuous contact
    (standard), single throw switch.

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-22-2016 at 03:55 PM
    What happens if you disconnect the Pi from the Sainsmart and provide 5V power to only the relay
    board? Are your outlets on or off then when wired to NC? What about NO in that same scenario?

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-21-2016 at 09:36 PM
    As stated earlier, I do have one weird issue where the outlets are on until the software starts
    which I work around by leaving the 220V and 110V that power the heaters and pumps unplugged
    until softwa...

  • Posted in thread: CraftBeerPi - Raspberry Pi Software on 11-21-2016 at 12:21 AM
    Presuming we are discussing CBP, no need to modify or add code for the PiFace. For 1-wire
    support when using a PiFace, however, you will need to get to one of the 3.3V pins (1 or 17)
    for power, pin 7 ...

0 COMMENTS
POST A COMMENT