Last Activity:03-13-2014 9:15 PM
Likes Given: 2
1 Likes on 1 Posts
Posted in thread: Mypin TA-7 PID with screw-in K probe, new in box with instructions, etc. on 02-25-2014 at 10:02 PM
Posted in thread: HomeBrewTalk 2014 Big Giveaway on 02-12-2014 at 06:20 PM
Posted in thread: Spike Brewing 12.5 Gallon Conical Fermenter Giveaway! on 01-06-2014 at 09:18 PM
Posted in thread: Blichmann Natural Gas Burner issue on 08-12-2013 at 12:36 PM
I use blichmann burners with natural gas all the time and have had no problem getting a
vigorous boil with > 10 gallons. It looks like perhaps you don't have enough gas flow: I get
bigger jets of flam...
Posted in thread: Brewer's Hardware 15 Gallon Stainless Steel Conical Fermenter Giveaway! on 07-26-2013 at 10:31 PM
Posted in thread: WSM Advice on 06-07-2013 at 06:39 PM
Do you guys see a need for the larger version or stick with the 18.5? Most likely only do a
butt or 2 at the most. Venison, Few racks of ribs, few salmon fillets is my past
experiences.The 18.5 will e...
Posted in thread: WSM Advice on 06-06-2013 at 04:35 AM
With a full ring of charcoal, my 18.5 will hold 225-275 for 12+ hours in moderate (60+) temps.
When doing a butt, I usually start early in the morning, get the WSM up to temperature, put on
the butt, ...
Posted in thread: Any Homebrew Clubs that Brew together? on 06-05-2013 at 07:13 PM
Hi,I'm a member of CHAOS, and I live in Logan Square. The great thing about CHAOS for me is
that a majority of the equipment you need for going all grain (mill, burners, pots, MLTs) is
available for u...
Posted in thread: Fermenter Stopper Shot Up To Ceiling???? on 06-05-2013 at 06:13 PM
If you buy a mini fridge for fermentation, check out this thread for info on building an
inexpensive temperature controller, which will allow your fridge to go into the 60s for ale
fermentation (or th...
Posted in thread: Homemade RIMS system and water filter build on 06-03-2013 at 02:29 PM
Steven,I built a brewershardware RIMS tube for use with a PID, so I used the same PT100 sensor
that Jason does. My sensor ended up malfunctioning, and I can verify that brewershardware no