Last Activity:11-27-2015 11:00 PM
Likes Given: 14
Posted in thread: Induction BIAB on 04-26-2015 at 02:29 AM
Same burner I use for BIAB, love it. I'm surprised you can maintain a good boil at 1500w, I
need at least 2000w to maintain a good boil with about 4.5 gal of wort.Mine is insulated with 5
wraps of ref...
Posted in thread: Induction BIAB on 04-25-2015 at 08:38 PM
in the all grain recirculation it is a challenge to keep from clogging but if you can just lift
the bag up and drop it down every time it clogs and your setI think with a bigger grain bill I
will use ...
Posted in thread: Induction BIAB on 04-25-2015 at 08:20 PM
So I finally set up the Avantco IC3500Bayou 1044 wrapped with reflectix1st brew was with
steamer basket and bag insideI use a chugger pump to recirculate through a rims, the basket
just doesnt work, I...
Posted in thread: The HomeBrewTalk 2015 Big Giveaway! on 04-09-2015 at 09:38 PM
Posted in thread: Request for Induction Equipment Information on 03-07-2015 at 10:35 PM
First test (just water)Avantco IC3500Bayou 1044 wrapped 5 times with reflectix (no lid) filled
to brimOutside 42 degreesFull 3500 watt setting50 mins to 158 mash in12 mins to 176 mash out20
mins to bo...
Posted in thread: Induction Burner Help on 03-07-2015 at 01:54 PM
Reflectix, wrap the kettle use the silver duct tape to sealMost hardware stores carry itCheers
Posted in thread: Water flow for mash/sparge on 12-02-2014 at 11:13 PM
Model Number:YF-S201Product Description G1/2" Water heater flow sensor, water flow meter Scope:
Suitable for water heaters, credit card machines, water vending machines, and other flow
Posted in thread: Water flow for mash/sparge on 11-30-2014 at 08:36 PM
I have it setup on output of pump, I use it from HLT to Mash only, I set it for amount of
liters needed, it beeps when amount is reached, it might not be 100% accurate but close enoughI
like the idea ...
Posted in thread: BrewsBySmith 2 stage Fermentation Temperature Controller Giveaway! on 10-23-2014 at 10:40 PM
Posted in thread: Water flow for mash/sparge on 10-22-2014 at 11:29 PM
anyone tried setting up anything like these to control flow to mashCheersPaul;)