Last Activity:12-06-2013 7:54 PM
Likes Given: 11
1 Likes on 1 Posts
Posted in thread: Basement Brew Sink : What kind of drain pump? on 12-08-2013 at 01:57 AM
I like the Harbor Freight idea - especially since I have a 25% off coupon. What check valve did
you get? Does it go on the sink (inlet) or drain (outlet)? Do you need to vent the bucket?
Posted in thread: Basement Brew Sink : What kind of drain pump? on 12-06-2013 at 09:42 PM
I've clogged SWMBO's laundry sink one too many times from cleaning trub and gunk out of kegs
and kettles, so I'm looking at getting my own utility sink in the basement. This will be below
the level of...
Posted in thread: Rebel Brewer Giveaway! on 11-21-2013 at 05:55 PM
Posted in thread: Philly area Homebrewers on 11-19-2013 at 05:55 PM
It looks like the local group buy just finished, so it's going to be a while before the next
one. Does anyone have an extra sack or two of malt? I'm especially looking for Maris Otter, but
could use a...
Posted in thread: FT : 2.5 gal corny for... (Philly) on 11-18-2013 at 04:30 PM
I paid $70 each, and I'd like to get as close to that as possible since these are in good shape
(only used 3 or 4 times) and don't depreciate that quickly. I have up to 4 available, and would
Posted in thread: FT : 2.5 gal corny for... (Philly) on 11-18-2013 at 02:43 PM
Would you consider selling them outright?Definitely, but shipping is probably going to kill the
deal if you're not local.
Posted in thread: FT : 2.5 gal corny for... (Philly) on 11-17-2013 at 03:09 AM
I have some extra 2.5 gallon cornies. They're these: looking to trade for sacks of base malt,
14" pulley for motorizing a mill, or make an offer.I don't want to ship anything at the moment,
but I ca...
Posted in thread: JEnglish eBIAB Dual 2000W 120V Recirculating Build on 11-14-2013 at 05:38 PM
I happen to have a spare twist-lock male inlet (NEMA L5-20P) and 20-amp (NEMA 5-20P) to
twist-lock female (NEMA L5-20R) extension cord. I was going to use it for a 2000W 120V RIMS
toolbox, but changed...
Posted in thread: Contemplating RIMS vs. direct fire mash tun on 11-14-2013 at 05:18 PM
I have almost the same setup. I use a 2000W element instead of 1500W, and I have a false bottom
from Jay at NorCal, plus the "deluxe" 2-inch RTD probe from Auberins (not sure if they're still
Posted in thread: Looking for a grain mill on 11-11-2013 at 04:53 PM
These may be a little bit of a commute for you, but grain mills do come up on Craigslist:Malt
Mill for $150 in Feasterville PA: https://philadelphia.craigslist.org/sno/4174174721.htmlPhil
Mill for $10...