VIEW MY

aamcle

Gift Premium Subscription To aamcle

Join Date:

01-07-2013

Last Activity:

02-27-2015 7:04 AM

2 Likes on 2 Posts 

LATEST ACTIVITY

  • Posted in thread: Removing all trace of solder from Stainless? on 01-29-2015 at 10:49 PM
    Evening All.I have an old Stainless urn type vessel with the bottom soldered into place, I'd
    like to use it for a GrainFather type build.I can get the bottom out using a torch to melt the
    solder but h...

  • Posted in thread: Blichmann BrewEasy on 01-29-2015 at 07:08 PM
    Just common pipe insulation the foam tube type you should be able to get it easily.Atb. Aamcle

  • Posted in thread: Blichmann BrewEasy on 01-29-2015 at 03:26 AM
    Cookinwood, would you be able to measure how long it takes the grain bed to achieve target mash
    temperature after dough in and the start of recirculation?Many thanks. Aamcle

  • Posted in thread: Blichmann BrewEasy on 01-29-2015 at 12:12 AM
    Would it be possible to reduce the dough in temperature discrepancy by having as much strike
    water in the MT as possible? Dough in then let it drain to whatever level you want.In effect
    setting up wit...

  • Posted in thread: Wiring RS485 / PID. on 01-27-2015 at 09:36 PM
    Sorted I hope! I've finally found enough details of the adapter to let me when wire up.Thanks.
    All. Aamcle

  • Posted in thread: Wiring RS485 / PID. on 01-27-2015 at 07:48 PM
    I have a RJ485 adapter/Virtual com port unit that plugs into a USB port it has a RJ45
    receptacle (female socket). It's USB one end and RJ45 at the other.I now need a cable to run
    from it to a socket o...

  • Posted in thread: Wiring RS485 / PID. on 01-27-2015 at 03:01 PM
    Thanks Crane, but I'm still stuck.On my PID connection 11 is - Data and 12 is + Data and I have
    to connect wires to them they are not prewired just screw terminals.If I connect a wire to 11 -
    Data whi...

  • Posted in thread: Wiring RS485 / PID. on 01-26-2015 at 08:39 PM
    Evening All.I've finally managed to set up a virtual com port on my old net book, this should
    alow it using the appropriate software to control my PID.The PID outputs data+ and data - I
    need to connec...

  • Posted in thread: HOWTO - Make a BrewPi Fermentation Controller For Cheap on 01-26-2015 at 12:03 PM
    A quick question, as the brewpi has a PID function and supports relays, what stops me replacing
    the 10A relays with 20A SSRs and using it to control mashing?I have stc1000s controlling my
    fridge and f...

  • Posted in thread: In Bag Circulator on 01-20-2015 at 06:12 PM
    Oh an upgrade on a BrewEasy 😷 I've supposed to be building something like that but I've
    run into a wall.I contacted Blichman apparently holding temp isn't an issue, I'd still insulate
    everythi...

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS