Yavid

LATEST ACTIVITY

• Posted in thread: Advice for Auber Temperature Controller settings? on 06-11-2013 at 02:29 AM
  Are the T-20 and AT-2 the only settings you changed from the default Auber settings? I just
  finished wiring up my control panel and I'm just about ready to fire my unit up (fingers
  crossed that everyt...

• Posted in thread: Gas and Temperature Control for Dummies on 04-04-2013 at 12:53 AM
  What is everyone using to connect the gas valves to their burners? The gas valves I am using
  have 3/4" FNPT threads. The NG orifices on my burners have 3/8" male flares. I was thinking I'd
  use a 3/4"-...

• Posted in thread: Gas brewstand - need high voltage disconnect for spark wire - any ideas? on 03-28-2013 at 03:05 AM
  Looks like I was thinking of the right thing after reading stakon. Those will not work for what
  I'm trying to do. And if I am using rubber grommets I won't need a connector at all, I'll just
  run a con...

• Posted in thread: Gas brewstand - need high voltage disconnect for spark wire - any ideas? on 03-28-2013 at 12:00 AM
  Would you mind sending me a pic of what you mean by stakon? If it's what I'm thinking of it's
  not something that I can panel mount to the enclosure. I don't think I'm understanding your
  suggestion.

• Posted in thread: Gas brewstand - need high voltage disconnect for spark wire - any ideas? on 03-27-2013 at 05:10 PM
  Wires are run just like the ones shown in the schematic ( The 24V transformer connects to the
  Honeywell intermittent pilot control and the spark output wire goes from the pilot control to
  the ignitor...

• Posted in thread: Gas brewstand - need high voltage disconnect for spark wire - any ideas? on 03-27-2013 at 04:04 PM
  I am in the planning stage of building a control panel for my temp controlled natural gas
  brewstand. My build is based on this post: like to put all of the electronics that make this
  system work into...

• Posted in thread: Temp Control Circuit & Control Panel Help Needed on 03-20-2013 at 05:43 PM
  Thanks for the help. I'll have to use 3 separate 24V transformers instead of just using 1 like
  I was going to (found one with a high enough rating that it will power up to 3 of the
  controllers/gas val...

• Posted in thread: Temp Control Circuit & Control Panel Help Needed on 03-20-2013 at 01:22 AM
  I'm currently building a single tier brew stand with temp control and I need a little help
  figuring out my control panel. The basic circuit for controlling my burners was taken from this
  post: copied...

• Posted in thread: anyone have 3 empty white labs yeast vials laying around?? on 03-19-2013 at 12:55 PM
  I have a few empty vials I could send you. I am in Canada though. If you're interested shoot me
  a PM with your address and I'll try to figure out how much shipping will be.

• Posted in thread: Gas and Temperature Control for Dummies on 03-18-2013 at 08:27 PM
  Thanks. That's what I thought but wanted to make sure before I return anything.Can someone get
  in touch with Sawdustguy so he can edit the original post? I'm sure I'm not the first (and prob
  not the l...