Last Activity:02-16-2014 6:14 PM
Likes Given: 2
2 Likes on 2 Posts
Posted in thread: A Keezer evolves on 11-07-2012 at 03:44 PM
Great job! What did you use for the lights on the coffin?
Posted in thread: Windows 8 on 11-05-2012 at 06:56 PM
On my 2-year-old laptop, with 6-month-old hybrid HDD, bootup and even general performance is
notably faster under Win 8.I'm eager to see how the cross-device synchronization works once
Windows Phone 8...
Posted in thread: The K-State Keezer! on 10-31-2012 at 01:42 AM
Best of luck on your build! I agree with Hopp on his make 4 taps recommendation. I was only
going to build a 3 tap for the same reason you state, but I am glad I did the 4th tap now. Feel
free to ask ...
Posted in thread: The K-State Keezer! on 10-31-2012 at 01:34 AM
Here's the inside of the coffin, with the cold air channels in the front and the electrical in
the back. The black box is the temperature controller, wired to the blue two-gang electrical
box. One of ...
Posted in thread: The K-State Keezer! on 10-30-2012 at 07:43 PM
Honestly, I think 3 inches is fine unless you are going with bulky tap handles, like the
chalkboard handles or some other beefy handle.....then it might get a little tight.OK good. I
wasn't super exci...
Posted in thread: The K-State Keezer! on 10-30-2012 at 06:41 PM
I believe my coffin was 20 inches wide, not counting the beer glass shelves on the sides, but I
can double check when I get home. My taps are are spaced 4 inches on center. Just make sure
that you lea...
Posted in thread: The K-State Keezer! on 10-30-2012 at 02:08 PM
100% in agreement with this post. I started with 3 taps and within a couple of months,
re-trimmed the front of the coffin and added the 4th. If you have the capacity to fit 4 kegs,
eventually you will...
Posted in thread: The K-State Keezer! on 10-30-2012 at 02:07 PM
Too bad Oregon is going to jump you in the standings and play for NC again....nice keez
thoughI'm not convinced this is actually true, despite how much ESPN wants it to be!Well, since
both parents, 3 ...
Posted in thread: The K-State Keezer! on 10-30-2012 at 02:00 PM
Oh...a couple of questions on the build. What are you doing for coffin cooling. Is there a gap
between the cabinet and the freezer wall? I can offer advice on these areas if needed. Good
luck and I'll...
Posted in thread: The K-State Keezer! on 10-29-2012 at 07:44 PM
So after far too long browsing this forum, and too much frustration with bottling, I've decided
it's time to start kegging. And of COURSE if I'm going to be kegging, I have to have a keezer
to go with...