VIEW MY

RocketBrewer

Gift Premium Subscription To RocketBrewer

Join Date:

02-26-2012

Last Activity:

02-10-2016 3:28 AM

Likes Given: 59

74 Likes on 50 Posts 

    ABOUT ME

  • Rocket Surgeon
  • Wee Heavy
  • Rye IPA
  • None at the moment
  • None at the moment
  • Tap 1- Smokey Bacon Red, Tap 2- Black Rye IPA, Tap 3- CA Pale Ale, Tap 4- Citra M.O. SMASH, Rocket Red Ale, Tap 6- Kolsh
  • Male
  • Married
  • Garden Valley
  • CA

LATEST ACTIVITY

  • Posted in thread: Using Grapefruit Peel in Primary on 02-07-2016 at 03:27 PM
    I soaked 3 oz. of zest in 4 oz. of vodka for 2 days, then dumped vodka and zest into a dry
    hopping container in the keg. Pulled it after a couple days and the flavor was amazing. Doing
    it in the ferme...

  • Posted in thread: CheekyMonk Brewery 50amp Build on 02-05-2016 at 05:37 PM
    Your welds will be fine. They don't need to be sanitary for a BK.I'd clean them good with Bar
    Keepers Friend to passivate them a little.

  • Posted in thread: CheekyMonk Brewery 50amp Build on 01-31-2016 at 04:46 PM
    Nice build TylerAI! I love the use of the pipe cleaners, lets you adjust and move things around
    without wasting wire. Great job!

  • Posted in thread: BrunDog 50A eRig - no HLT for me! on 01-30-2016 at 11:42 PM
    I don't know... Make some beer?

  • Posted in thread: First run on new HERMS -- BIG problems! on 01-30-2016 at 06:33 PM
    You're likely fighting small amounts of grain getting past your false bottom, I had the same
    problem. It becomes very difficult to fly sparge because small bits of grain clog your ball
    valve and when ...

  • Posted in thread: Electric Brewery timer on 01-30-2016 at 05:36 PM
    The wiring diagram for the Auber can be found on the website. Here is the current version they
    sell. It is pretty straight forward with AC connections and output for an alarm. The other
    connections (t...

  • Posted in thread: BrunDog 50A eRig - no HLT for me! on 01-30-2016 at 05:22 PM
    I intended to just check out a few minutes of your video, ended up watching the whole thing!
    Just mesmerized by that system, AMAZING BUILD! :mug:

  • Posted in thread: Work shop to brew house build on 01-29-2016 at 04:39 PM
    Love the outdoor tap!

  • Posted in thread: Chugger pumps...impeller seizing? on 01-28-2016 at 01:05 PM
    I have the same issue with both my Chugger pumps to some extent, one is worse than the other.
    I'm not sure if cavatation is causing it to decouple, but higher temps obviously increase the
    problem. I'v...

  • Posted in thread: My MM3 grain mill on 01-24-2016 at 04:24 PM
    Nice build! Do you have any more info on your speed controller? where you got it, cost, etc.
    Have you milled with it yet?

CLUBS:
  • Placer Ultimate Brewers Society (PUBS)
    Placer Ultimate Brewers Society (PUBS)
0 COMMENTS
POST A COMMENT