Last Activity:11-23-2015 4:22 PM
27 Likes on 26 Posts
Posted in thread: HomebrewSupply Recipe Giveaway on 11-04-2015 at 06:53 PM
Include me please
Posted in thread: Successes and failures with grain mills, what mill has worked best for you? on 10-30-2015 at 08:59 PM
I only have used the MM2-2.0, so I can't compare to anything else. I've been happy with mine.
About a year ago I did some fairly extensive research for my mill purchase, and I concluded
that the MM is...
Posted in thread: HomeBrewSupply Amcyl Brew Kettle w/ 3-Piece Ball Valve Giveaway! on 07-28-2015 at 06:30 AM
Posted in thread: Can you put those orange carboy caps in the dishwasher? on 07-11-2015 at 11:48 PM
Hi all,When I clean my carboys, I usually just use the same sodium percarbonate solution to
clean off the carboy cap as well. But with the last RIS, I had a pretty big blowoff, and the
cap is rather g...
Posted in thread: OK so what exactly is in pH cleaning solution? on 12-21-2014 at 07:19 PM
OK good deal, thank you for the reply. I was pretty much assuming that, but good to have it
confirmed, so I can be confident in my safety!
Posted in thread: OK so what exactly is in pH cleaning solution? on 12-20-2014 at 11:34 PM
Alrighty so not to belabor my stupidity, but about 5 ml of Miwaukee pH electrode cleaning
solution ended up in my mash (!)Trying to figure out if this is game over for my brew or not.
The MSDS is enti...
Posted in thread: BeerBug - Can you use a 3rd party temp probe? on 12-01-2014 at 02:19 AM
OH I see! So the thing doesn't become a new cap for the carboy, it's just a little thing that
goes into the airlock port? That will be just fine then, as you say I could use the thermowell
bung and th...
Posted in thread: BeerBug - Can you use a 3rd party temp probe? on 11-30-2014 at 10:37 PM
Right, but the thermometer that goes with it can't send the info to an external controller to
raise or lower the temp, right? That's what I want to do - use the BeerBug for informational
Posted in thread: BeerBug - Can you use a 3rd party temp probe? on 11-30-2014 at 10:11 PM
Hi Brewers,I've been looking at the BeerBug, and was considering putting it on the Xmas list as
a fun little item of brewing hardware that I wouldn't spend my own money on.As I understand it,
Posted in thread: Grain Mill Rec's on 11-21-2014 at 07:28 PM
Yup...leaning towards MM2-2.0 with base and hopper. Will my Dewalt 18V cordless drill fit the
shaft on it?I'm about to pull the trigger on the same purchase. My only drills are 3/8 and
probably are to...