Last Activity:05-07-2015 4:41 AM
Likes Given: 3
29 Likes on 22 Posts
Posted in thread: Rib-cage vs small coil in a large coil on 01-17-2015 at 05:55 AM
I'm interested to see what you are building. I've got an idea that I think is the next
innovation in chillers but I would really like to see what you've got brewing. Post pictures
and chill times with...
Posted in thread: Home Built Grain Mill - From Scratch on 01-17-2015 at 05:51 AM
I should probably PM you this... but... I've been looking into doing what you just did for
certain reasons. I've noticed that there is a deficiency with current grain mill design for
home brewers whic...
Posted in thread: Share your "man-crush" thread? on 01-12-2015 at 04:57 AM
Bradley Cooper. But then again, I kinda look like him, and I have the same first name....
Posted in thread: Quick immersion chiller question on 01-12-2015 at 02:10 AM
I'm going to make an immersion chiller and I was going to use 50ft of 1/2" od. Is it worth the
price to use that over 3/8"od? What have you guys found? Most sites sell the 3/8" and I don't
know if tha...
Posted in thread: Quick immersion chiller question on 01-12-2015 at 02:03 AM
I got a tremendous deal on some 5/8" a while back and made a dual pass IC, the water goes into
the bottom of both coils, and the water comes out the top of both coils; basically a "rib cage"
Posted in thread: Autolysis. on 01-01-2015 at 11:57 PM
I have a beer that has been on the yeast for about 4 years. I brewed it, my gf left me and I
was in a bad place in life for a long time. The carboys have just been sitting there for years,
i wonder if...
Posted in thread: New mill - one man operation? on 01-01-2015 at 08:52 PM
I do it myself. I pour in the grain then run the drill. Sure a few kernels fall through but
it's literally an extremely tiny amount that makes no affect on efficiency. Just ordered a
Monster Mill myse...
Posted in thread: 35 gallon conical for sale on 12-31-2014 at 10:01 PM
Wow man, thats an incredible decision to make. I wish I was in the market for these items, I'm
currently looking for a grain mill if you have one of those?
Posted in thread: DIY Interwoven "Rib-Cage" Immersion Chiller on 12-29-2014 at 03:35 AM
I built this after I stumbled into a 60 foot coil of 1/4" copper water line on clearance for
$36. The deal was too good to pass up.You have 565in^2 of chilling area (give or take of
course, depending ...
Posted in thread: DIY Interwoven "Rib-Cage" Immersion Chiller on 12-29-2014 at 03:31 AM
Surface area of different diameter and lengths of tubing:25' of 1/4" - 235inē50' of 1/4" -
471inē60' of 1/4" - 535inē25' of 3/8" - 353inē50' of 3/8" - 707inē60' of 3/8" - 848inē25' of
1/2" - 471inē50'...