VIEW MY

PJM

Gift Premium Subscription To PJM

Join Date:

06-14-2010

Last Activity:

08-24-2016 1:19 PM

Likes Given: 1

25 Likes on 20 Posts 

    ABOUT ME

  • Soccer,Tennis
  • Chinook IPA
  • Male
  • Married
  • Wheeling
  • WV

LATEST ACTIVITY

  • Posted in thread: Mounting chugger pumps on the stand. High or Low? on 08-09-2016 at 11:05 AM
    PJM are those the side inlet or center inlet pumps? Center inlet seems odd pointed down.Oh,
    sorry about that. Mine are the side inlet. Center inlet would seem odd pointing down.

  • Posted in thread: Mounting chugger pumps on the stand. High or Low? on 08-06-2016 at 11:10 AM
    My experience has been that it works best to orient the pump head so that the inlet to the pump
    is pointing down towards the floor. Not sure if that helps in your setup or not.

  • Posted in thread: Water Chemistry Beyond the Primer Lots of Questions Would Appreciate Your Help on 08-06-2016 at 10:45 AM
    I add my brewing salts to the mash tun rather than to the strike water in the HLT. Just mix it
    in as you add the strike water to the mash tun.

  • Posted in thread: Beer in Ft Lauderdale on 05-18-2016 at 09:53 AM
    Check out Lauder Ales Brewery. Cool little place and the beers were very good.

  • Posted in thread: Water. AGAIN :-) on 01-29-2016 at 04:47 PM
    If it is RO water I think it is safe to assume that it has zero minerals in it. At least that
    is what i do. So you can use water calculators like bru'n water, EZ water and the like.

  • Posted in thread: CO2 tanks. Inside or Outside? on 12-06-2015 at 01:46 PM
    I have mine inside as well. It does take up a lot of room. It also leaves rust rings on the
    bottom of the keezer (steel tank).

  • Posted in thread: Pittsburgh/Western PA Group By #9+ on 12-02-2015 at 07:50 PM
    I am in need of some grain too.

  • Posted in thread: Stainless ball vaves on 11-19-2015 at 04:39 PM
    Lead, specifically.

  • Posted in thread: Stainless ball vaves on 11-19-2015 at 04:38 PM
    My understanding is that brass may leech bad things into the wort.

  • Posted in thread: Using a hydrometer to check pre boil gravity technique? on 10-01-2015 at 02:28 AM
    I don't chill mine at all. Just stir the wort, take a sample and then plug the number and
    temperature into a program that corrects for temperature.

0 COMMENTS
POST A COMMENT